HardLabs

AlteFabrik191126

25mmHg·AlteFabrik191126·PCB/FF2_20241213_1510/FF2_20241213_1510.kicad_pcb

AlteFabrik191126 PCB layout, top view — open source AVR/Arduino board by 25mmHg

About the AlteFabrik191126 PCB

AlteFabrik191126 is an open source AVR/Arduino PCB design by 25mmHg, published on GitHub under the BSD-3-Clause license. It is a 2-layer board measuring 27.9 × 15.2 mm, with 10 components from 8 distinct parts.

Its main chip is the ATtiny13A-P, from the AVR/Arduino family. By type, the board carries 2 LEDs, 2 inductors, 2 capacitors, 1 IC, 1 connector and 1 diode.

From the project

Flimmerfeen2.0

Main components on the AlteFabrik191126

ATtiny13A-P

AlteFabrik191126 bill of materials (BOM)

10 components, 8 distinct parts.

QtyPartRefs
1
ATtiny13A-P
U1
1
PINHD_1x3_Male
J1
2
LS A676 (side red)
LED1, LED2
1
LED unused
D1
2
B78148S1334J000
L1, L2
1
100uF 10V
C1
1
100nF 1206
C2
1
1k
R1

AlteFabrik191126 design files

The KiCad project lives in the 25mmHg/AlteFabrik191126 repository on GitHub; these links point at the commit this page was built from.

AlteFabrik191126: common questions

What microcontroller does the AlteFabrik191126 use?

The AlteFabrik191126 is built around the ATtiny13A-P, from the AVR/Arduino family.

How big is the AlteFabrik191126 PCB?

The AlteFabrik191126 measures 27.9 × 15.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the AlteFabrik191126?

10 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the AlteFabrik191126 design files?

From the 25mmHg/AlteFabrik191126 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the AlteFabrik191126 design in my own project?

Yes, under the terms of its BSD-3-Clause license, which 25mmHg chose for the repository.

Can I test firmware for the AlteFabrik191126 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards