HardLabs

Ece411-group10

ajm27pdx·ece411-group10·CAD/CAD.kicad_pcb

Ece411-group10 PCB layout, top view — open source AVR/Arduino board by ajm27pdx

About the Ece411-group10 PCB

Ece411-group10 is an open source AVR/Arduino PCB design by ajm27pdx, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 55.9 × 57.8 mm, with 17 components from 10 distinct parts.

Its main chip is the Arduino_UNO_R3, from the AVR/Arduino family. Other key parts include the RFID_RC522 and LCD_1602_I2C. By type, the board carries 8 resistors, 2 ICs, 2 modules, 2 switches and 1 transistor.

It belongs with the sensors designs in this gallery.

From the project

Portland State University ECE411 Practicum Group

Ece411-group10, from the project README
From the project README

Main components on the Ece411-group10

RFID_RC522LCD_1602_I2CArduino_UNO_R3

Ece411-group10 bill of materials (BOM)

17 components, 10 distinct parts.

QtyPartRefs
1
RFID_RC522
U1
1
LCD_1602_I2C
U2
1
Arduino_UNO_R3
A1
1
Motor_Servo_Hitec
M1
1
2N7002
Q1
1
D_Laser_1C2A
LD1
1
R_Photo
PR1
2
SW_Push
SW1, SW2
6
10k
R1, R2, R5, R6, R7, R8
2
4.7k
R3, R4

Ece411-group10 design files

The KiCad project lives in the ajm27pdx/ece411-group10 repository on GitHub; these links point at the commit this page was built from.

Ece411-group10: common questions

What microcontroller does the Ece411-group10 use?

The Ece411-group10 is built around the Arduino_UNO_R3, from the AVR/Arduino family.

How big is the Ece411-group10 PCB?

The Ece411-group10 measures 55.9 × 57.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ece411-group10?

17 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Ece411-group10 design files?

From the ajm27pdx/ece411-group10 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Ece411-group10 design in my own project?

Yes, under the terms of its GPL-3.0 license, which ajm27pdx chose for the repository.

Can I test firmware for the Ece411-group10 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards