Daplink

andy666chang·DAPLink·hardware/daplink/daplink.kicad_pcb

Daplink PCB layout, top view — open source STM32 board by andy666chang

About the Daplink PCB

Daplink is an open source STM32 PCB design by andy666chang, published on GitHub. It is a 2-layer board measuring 50 × 20 mm, with 35 components from 23 distinct parts.

Its main chip is the STM32F103CBTX, from the STM32 family. Other key parts include the AMS1117-3.3. By type, the board carries 15 resistors, 9 capacitors, 4 connectors, 3 diodes, 2 ICs and 1 crystal.

Main components on the Daplink

Daplink bill of materials (BOM)

35 components, 23 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
AMS1117-3.3
U1
1
STM32F103CBTX
STM32F103CBTx
U2
1
8MHZ
8MHz
Y1
1
CONN_01X04
Conn_01x04
J1
2
CONN_01X05
Conn_01x05
J2, J3
1
USB_C_PLUG_USB2.0
USB_C_Receptacle_USB2.0
P1
1
RST
RST1
1
LEDG
D1
1
LEDB
D2
1
LEDR
D3
3
10NF
10nF
C1, C4, C8
2
10UF
10uF
C2, C3
2
20PF
20pF
C5, C6
2
18PF
18pF
C7, C9
1
10K
5K1
R1
4
10K
R2, R3, R4, R11
1
100
R5
2
1K5
R6, R7
1
470
R8
2
4K7
R9, R10
Show 3 more
QtyPartRefs
2
33
R12, R13
1
5K1
R14
1
1K5
R15

Daplink design files

The KiCad project lives in the andy666chang/DAPLink repository on GitHub; these links point at the commit this page was built from.

Daplink: common questions

What microcontroller does the Daplink use?

The Daplink is built around the STM32F103CBTX, from the STM32 family.

How big is the Daplink PCB?

The Daplink measures 50 × 20 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Daplink?

35 components, from 23 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Daplink design files?

From the andy666chang/DAPLink repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Daplink design in my own project?

The repository has no license, so all rights stay with andy666chang. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Daplink without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in DAPLink

Similar boards