HardLabs

Stm32f breakout

apistol78·rv32·schematics/stm32f breakout/stm32f breakout/stm32f breakout.kicad_pcb

Stm32f breakout layout, top view — open source STM32 board by apistol78

About the Stm32f breakout

Stm32f breakout is an open source STM32 PCB design by apistol78, published on GitHub. It is a 2-layer board measuring 27.4 × 63.3 mm, with 3 components from 2 distinct parts.

Its main chip is the STM32F103C6Tx, from the STM32 family. By type, the board carries 2 connectors and 1 IC.

It belongs with the audio and dev boards & breakouts designs in this gallery.

From the project

Risc-V pipelined CPU and SoC written in SystemVerilog

After everything has been built you should be able to run the emulators:

Written using SystemVerilog and are split up into logical pieces where each stage of the pipeline is in a separate module:

Main components on the Stm32f breakout

STM32F103C6Tx

Stm32f breakout bill of materials (BOM)

3 components, 2 distinct parts.

QtyPartRefs
1
STM32F103C6Tx
U1
2
Conn_01x24_Male
J1, J2

Stm32f breakout design files

The KiCad project lives in the apistol78/rv32 repository on GitHub; these links point at the commit this page was built from.

Stm32f breakout: common questions

What microcontroller does the Stm32f breakout use?

The Stm32f breakout is built around the STM32F103C6Tx, from the STM32 family.

How big is the Stm32f breakout?

The Stm32f breakout measures 27.4 × 63.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Stm32f breakout?

3 components, from 2 distinct parts. The full bill of materials is listed on this page.

Where can I download the Stm32f breakout design files?

From the apistol78/rv32 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Stm32f breakout design in my own project?

The repository has no license, so all rights stay with apistol78. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Stm32f breakout without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in rv32

Similar boards