Arta board
Artarobotics-team·arta-board·hardware/kicad/arta_board.kicad_pcb
About the Arta board
Arta board is an open source PCB design by Artarobotics-team, published on GitHub under the CERN-OHL-P-2.0 license. It is a 4-layer board, with 1 components from 1 distinct parts.
Other key parts include the LTC2955-2.
It belongs with the robotics & motion designs in this gallery.
From the project
Main control PCB for an ESP32-S3 robot: 2S Li-ion (8.4 V) input with protection and soft-latch power control, 5 V / 3.3 V buck rails, 6x LEGO LPF2 motor H-bridges (TB67H450), 4x servos, BMI270 IMU, and an I2C expansion bus (TCA9548A). 4-layer board, fabricated at JLCPCB.
Main control PCB for an ESP32-S3 robot: 2S Li-ion (8.4 V) input with protection and soft-latch power control, 5 V / 3.3 V buck rails, 6x LEGO LPF2 motor H-bridges (TB67H450), 4x servos, BMI270 IMU, and an I2C expansion bus (TCA9548A). 4-layer board, fabricated at JLCPCB.
ESP32 firmware lives in a separate repository (not in this one).
Blocking effect: powerbuck.kicadsch must not be started until items 1–2 are confirmed; motors.kicadsch` must not be started until item 3 is confirmed.
Main components on the Arta board
Arta board bill of materials (BOM)
1 components, 1 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | LTC2955-2 Analog Devices | U1 |
Arta board design files
The KiCad project lives in the Artarobotics-team/arta-board repository on GitHub; these links point at the commit this page was built from.
Arta board: common questions
How big is the Arta board?
The Arta board has 4 copper layers and is 1.6 mm thick.
How many components are on the Arta board?
1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Arta board design files?
From the Artarobotics-team/arta-board repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Arta board design in my own project?
Yes, under the terms of its CERN-OHL-P-2.0 license, which Artarobotics-team chose for the repository.
Similar boards
Stack chan
stack-chan
50 × 50 mm33 parts2LApache-2.01.7kCube batteryboard
willem-pennings
95 × 95 mm4 parts2LGPL-3.01.1kTrollerv2
rene-dev
100 × 75 mm33 parts4LGPL-3.0979Powerstep
rene-dev
95.2 × 71.5 mm28 parts4LGPL-3.097911ua
rene-dev
57.3 × 19 mm26 parts2LGPL-3.0979Diff driver
rene-dev
32 × 22 mm14 parts2LGPL-3.0979