Display Carrier

AxxAxx·AxxSolder·Other/Display_Carrier/Display_Carrier.kicad_pcb

Display Carrier PCB layout, top view — open source board by AxxAxx

About the Display Carrier PCB

Display Carrier is an open source PCB design by AxxAxx, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 35.6 × 58.2 mm, with 5 components from 5 distinct parts.

By type, the board carries 2 connectors, 2 resistors and 1 capacitor.

It belongs with the power & battery and displays & leds designs in this gallery.

From the project

STM32 Based soldering station for JBC cartridges, 9-24 VDC and USB-PD power

Interested in purchasing an AxxSolder 3.2? On my website 5Dimensions you can purchase assembled and tested AxxSolder 3.2 boards with connectors and hardware.

AxxSolder handles this by alternating between heating and measuring. Forty times a second a timer interrupt turns the heater off, waits 0.5 ms for the signal to settle, and triggers the ADC. The heater is switched back on as soon as the conversion is finished. The measurement window is short compared to the 25 ms between measurements, so very little heating power is lost and the control loop still gets a clean reading every cycle. On a…

Display Carrier, from the project README
From the project README

Display Carrier bill of materials (BOM)

5 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
USB4110-GF-A
Conn_01x08_Pin
GCT
J1
1
691243110009
Conn_01x12_Pin
Wurth Elektronik
J2
1
CL21A106KOQNNNE
10u
Murata Electronics
C1
1
CR0805-JW-103ELF
10k
Panasonic
R1
1
CR0805-FX-10R0ELF
10
Panasonic
R2

Display Carrier design files

The KiCad project lives in the AxxAxx/AxxSolder repository on GitHub; these links point at the commit this page was built from.

Display Carrier: common questions

How big is the Display Carrier PCB?

The Display Carrier measures 35.6 × 58.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Display Carrier?

5 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Display Carrier design files?

From the AxxAxx/AxxSolder repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Display Carrier design in my own project?

Yes, under the terms of its GPL-3.0 license, which AxxAxx chose for the repository.

More boards in AxxSolder

Similar boards