SMD Lauflicht

Binary-Kitchen·SMD_Lauflicht·Kicad_Files/SMD Lauflicht 0805-0603 v1_1.kicad_pcb

SMD Lauflicht PCB layout, top view — open source board by Binary-Kitchen

About the SMD Lauflicht PCB

SMD Lauflicht is an open source PCB design by Binary-Kitchen, published on GitHub under the CC0-1.0 license. It is a 2-layer board measuring 40 × 40 mm, with 54 components from 12 distinct parts.

Other key parts include the NE555 and 4017. By type, the board carries 24 resistors, 20 diodes, 3 ICs, 3 capacitors, 2 transistors and 1 battery holder.

From the project

The running light is achieved by a circuit of a clockgenerator NE555 (U1) and two shift registers TI4017 (U2, U3). The NE555 uses the clock signal to shift one bit through both shift registers. At the end the circuit is reset and the cycle starts anew. The outputs of U2 controls

The running light is achieved by a circuit of a clockgenerator NE555 (U1) and two shift registers TI4017 (U2, U3). The NE555 uses the clock signal to shift one bit through both shift registers. At the end the circuit is reset and the cycle starts anew. The outputs of U2 controls the 20 LEDs (D1-D20). Since the TI4017 only has 10 outputs, one output controls two LEDs. U3 controls one transistor each (Q1, Q2) using two outputs, which alternately pull D1-D10 or D11-D20 to GND. This process repeats itself.

SMD Lauflicht, from the project README
From the project README

Main components on the SMD Lauflicht

SMD Lauflicht bill of materials (BOM)

54 components, 12 distinct parts.

QtyPartRefs
1
NE555
U1
2
4017
U2, U3
2
BC850
Q1, Q2
1
CR2023
BT1
1
SW_DPDT_x2
SW1
20
0805 LED Red
D1, D2, D3, D4, D5, D6, D7, D8 +12
1
100n
C1
1
100n F
C2
1
1µ F
C3
20
82 Ohm
R1, R2, R3, R4, R5, R6, R7, R8 +12
2
100k Ohm
R21, R22
2
1k Ohm
R23, R24

SMD Lauflicht design files

The KiCad project lives in the Binary-Kitchen/SMD_Lauflicht repository on GitHub; these links point at the commit this page was built from.

SMD Lauflicht: common questions

How big is the SMD Lauflicht PCB?

The SMD Lauflicht measures 40 × 40 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the SMD Lauflicht?

54 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the SMD Lauflicht design files?

From the Binary-Kitchen/SMD_Lauflicht repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the SMD Lauflicht design in my own project?

Yes, under the terms of its CC0-1.0 license, which Binary-Kitchen chose for the repository.