HardLabs

Triggy

Broosky·Triggy·KiCad/Triggy.kicad_sch

This repository ships a schematic but no board layout.

About the Triggy PCB

Triggy is an open source AVR/Arduino PCB design by Broosky, published on GitHub. It is a board, with 14 components from 9 distinct parts.

Its main chip is the Arduino Nano V3, from the AVR/Arduino family. By type, the board carries 5 resistors, 4 diodes, 2 modules, 2 switches and 1 transistor.

From the project

Automated event trigger with pre-defined times on configurable profiles.

An automated event executor that triggers actions based on pre-defined times and configurable profiles.

- Pulsing LED's with software PWM + gamma correction. - Review.

- Initial release. - Non RTC; uses compiled time to configure the clock.

Main components on the Triggy

Arduino Nano V3

Triggy bill of materials (BOM)

14 components, 9 distinct parts.

QtyPartRefs
1
Arduino Nano V3
A1
1
Motor 3V
M1
1
TIP41
Q1
1
Engage
SW1
1
Bypass
SW2
3
LED
D1, D2, D3
1
1N4148
D4
4
330R
R1, R2, R3, R5
1
10k
R4

Triggy design files

The KiCad project lives in the Broosky/Triggy repository on GitHub; these links point at the commit this page was built from.

Triggy: common questions

What microcontroller does the Triggy use?

The Triggy is built around the Arduino Nano V3, from the AVR/Arduino family.

How many components are on the Triggy?

14 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Triggy design files?

From the Broosky/Triggy repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the Triggy design in my own project?

The repository has no license, so all rights stay with Broosky. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Triggy without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards