HardLabs

Pami superstar

clubrobot·Cartes-elec·superstar/Pami_superstar.kicad_pcb

Pami superstar PCB layout, top view — open source AVR/Arduino board by clubrobot

About the Pami superstar PCB

Pami superstar is an open source AVR/Arduino PCB design by clubrobot, published on GitHub under the MIT license. It is a 2-layer board measuring 60 × 60 mm, with 10 components from 7 distinct parts.

Its main chip is the Arduino_Nano_v2.x, from the AVR/Arduino family. By type, the board carries 1 module and 1 resistor.

From the project

Repo de toutes les cartes électroniques utilisées par le CRINSA. Commencé en 2025 sous Kicad 8.0

TODO: - Finir le pcb principal - Finir le pcb règle - Faire le PCB du lidar - Faire le PCB du controlleur des afficheurs Leds-Matrix (ou en tout cas le reprogrammer) - Faire les 3 PCBs des Superstars

Main components on the Pami superstar

Arduino_Nano_v2.x

Pami superstar bill of materials (BOM)

10 components, 7 distinct parts.

QtyPartRefs
1
Arduino_Nano_v2.x
A2
3
Conn_01x03_Pin
IRl1, IRr1, Servo1
1
Conn_02x04_Top_Bottom
Motordriver1
2
Conn_01x02_Pin
Power1, Switch1
1
Conn_01x07_Pin
TCS34725
1
Conn_01x06_Pin
VL53L0X1
1
1k
R1

Pami superstar design files

The KiCad project lives in the clubrobot/Cartes-elec repository on GitHub; these links point at the commit this page was built from.

Pami superstar: common questions

What microcontroller does the Pami superstar use?

The Pami superstar is built around the Arduino_Nano_v2.x, from the AVR/Arduino family.

How big is the Pami superstar PCB?

The Pami superstar measures 60 × 60 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pami superstar?

10 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Pami superstar design files?

From the clubrobot/Cartes-elec repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Pami superstar design in my own project?

Yes, under the terms of its MIT license, which clubrobot chose for the repository.

Can I test firmware for the Pami superstar without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Cartes-elec

Similar boards