Light-Alarm-Clock

CodingGreatOwl·Light-Alarm-Clock·LED_shield/LED_shield.kicad_pcb

Light-Alarm-Clock PCB layout, top view — open source board by CodingGreatOwl

About the Light-Alarm-Clock PCB

Light-Alarm-Clock is an open source PCB design by CodingGreatOwl, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 31.3 × 49 mm, with 9 components from 8 distinct parts.

Other key parts include the LM7805_TO220. By type, the board carries 4 connectors, 2 capacitors, 1 IC, 1 diode and 1 resistor.

It belongs with the dev boards & breakouts and iot & wireless designs in this gallery.

From the project

Wake up naturally with LED lighting that activates 10 minutes before your alarm.

A hardware-software alarm clock system that combines an Android app, BLE communication, and an ESP32 firmware controller to trigger a pre-alarm light sequence before the alarm rings.

This project demonstrates end-to-end product engineering across mobile, embedded firmware, and electronics design.

Traditional alarms wake you up abruptly with sound. LightAlarmClock introduces a softer wake-up flow:

Main components on the Light-Alarm-Clock

Light-Alarm-Clock bill of materials (BOM)

9 components, 8 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
LM7805_TO220
U1
1
CON-left
J1
1
CON-Right
J2
2
SCREW_TERMINAL_01X02
Screw_Terminal_01x02
J3, J4
1
LD271
D1
1
0.33UF
0.33uF
C1
1
0.1UF
0.1uF
C2
1
68
R1

Light-Alarm-Clock design files

The KiCad project lives in the CodingGreatOwl/Light-Alarm-Clock repository on GitHub; these links point at the commit this page was built from.

Light-Alarm-Clock: common questions

How big is the Light-Alarm-Clock PCB?

The Light-Alarm-Clock measures 31.3 × 49 mm, has 2 copper layers and is 1.579 mm thick.

How many components are on the Light-Alarm-Clock?

9 components, from 8 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Light-Alarm-Clock design files?

From the CodingGreatOwl/Light-Alarm-Clock repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Light-Alarm-Clock design in my own project?

Yes, under the terms of its GPL-3.0 license, which CodingGreatOwl chose for the repository.

Similar boards