Uart-Sdi

ComNets-Bremen·MoleNet·Auxiliary Boards/Uart-Sdi12 Conversion Board/Uart-Sdi.kicad_pcb

Uart-Sdi PCB layout, top view — open source STM32 board by ComNets-Bremen

About the Uart-Sdi PCB

Uart-Sdi is an open source STM32 PCB design by ComNets-Bremen, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 51.4 × 25.5 mm, with 12 components from 11 distinct parts.

Its main chip is the STM32L073RZT6, from the STM32 family. Other key parts include the SN74LVC1G125DBVR and RFM95W. By type, the board carries 5 connectors, 4 resistors and 3 ICs.

It belongs with the rf & radio, iot & wireless and sensors designs in this gallery.

From the project

MoleNet: A Wireless Underground Sensor Network platform

This folder contains Kicad project files for Uart-Sdi12 conversion pcb.

Main components on the Uart-Sdi

Uart-Sdi bill of materials (BOM)

12 components, 11 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32L073RZT6
74AHC1G00
U1
1
SN74LVC1G125DBVR
74LVC2G241
U2
1
RFM95W
PC817
U3
1
SDI-12
J1
1
Unused Pin
J2
1
Screw_Terminal_01x02
J4
1
CONN_02X01
Screw_Terminal_01x02
J5
1
CONN_02X01
Screw_Terminal_01x08
J6
2
10K
10k
R1, R2
1
220
R3
1
220
1k
R4

Uart-Sdi design files

The KiCad project lives in the ComNets-Bremen/MoleNet repository on GitHub; these links point at the commit this page was built from.

Uart-Sdi: common questions

What microcontroller does the Uart-Sdi use?

The Uart-Sdi is built around the STM32L073RZT6, from the STM32 family.

How big is the Uart-Sdi PCB?

The Uart-Sdi measures 51.4 × 25.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Uart-Sdi?

12 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Uart-Sdi design files?

From the ComNets-Bremen/MoleNet repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Uart-Sdi design in my own project?

Yes, under the terms of its GPL-3.0 license, which ComNets-Bremen chose for the repository.

Can I test firmware for the Uart-Sdi without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in MoleNet

Similar boards