HardLabs

CE-PiicoDev-Potentiometer

CoreElectronics·CE-PiicoDev-Potentiometer·PCB/CE-PiicoDev-Potentiometer.kicad_pcb

CE-PiicoDev-Potentiometer PCB layout, top view — open source AVR/Arduino board by CoreElectronics

About the CE-PiicoDev-Potentiometer PCB

CE-PiicoDev-Potentiometer is an open source AVR/Arduino PCB design by CoreElectronics, published on GitHub under the MIT license. It is a 2-layer board measuring 25.4 × 25.4 mm, with 12 components from 9 distinct parts.

Its main chip is the ATtiny1616-M, from the AVR/Arduino family. By type, the board carries 4 resistors, 2 connectors, 1 IC, 1 jumper, 1 switch and 1 diode.

From the project

CE PiicoDev Potentiometer

This is the repo for the Core Electronics PiicoDev Potentiometer.

If you have any technical questions, or concerns about licensing, please contact technical support on the Core Electronics forums.

\"PiicoDev\" and the PiicoDev logo are trademarks of Core Electronics Pty Ltd.

Main components on the CE-PiicoDev-Potentiometer

ATtiny1616-M

CE-PiicoDev-Potentiometer bill of materials (BOM)

12 components, 9 distinct parts.

QtyPartRefs
1
ATtiny1616-M
U1
2
—
J1, J2
1
I2C PU
JP2
1
R_Potentiometer
RV1
1
ADDR
SW1
1
LED
D1
1
100n
C1
3
10k
R1, R2, R3
1
120R
R4

CE-PiicoDev-Potentiometer design files

The KiCad project lives in the CoreElectronics/CE-PiicoDev-Potentiometer repository on GitHub; these links point at the commit this page was built from.

CE-PiicoDev-Potentiometer: common questions

What microcontroller does the CE-PiicoDev-Potentiometer use?

The CE-PiicoDev-Potentiometer is built around the ATtiny1616-M, from the AVR/Arduino family.

How big is the CE-PiicoDev-Potentiometer PCB?

The CE-PiicoDev-Potentiometer measures 25.4 × 25.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the CE-PiicoDev-Potentiometer?

12 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the CE-PiicoDev-Potentiometer design files?

From the CoreElectronics/CE-PiicoDev-Potentiometer repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the CE-PiicoDev-Potentiometer design in my own project?

Yes, under the terms of its MIT license, which CoreElectronics chose for the repository.

Can I test firmware for the CE-PiicoDev-Potentiometer without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards