HardLabs

IO-SS50-6802

crsjones·68Retro·SWTPC/Bus/KiCad_Templates/IO-SS50-6802/IO-SS50-6802.kicad_pcb

IO-SS50-6802 PCB layout, top view — open source board by crsjones
Simulate this board

About the IO-SS50-6802 PCB

IO-SS50-6802 is an open source PCB design by crsjones, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 152.4 × 66 mm, with 1 components from 1 distinct parts.

It belongs with the retro computing designs in this gallery.

From the project

6800 and 6809 Retro Hardware

The SS-50 and SS-30 busses have been changed to reduce the size and make them more suitable for prototyping with breadboard and Dupont cables.

1. Connector pitch changed to 0.1" from 0.156".

2. Change power supply requirement to 5V only. 3. Remove the Baud Rate Generator from the Bus. 4. Changed non-inverting Data Bus Buffers.

The connector is the Molex 22-15-2106, I purchase them from Mouser (538-22-15-2106). 0.1" pin header and female receptacles are a cheaper option but not recommended for more than a few insertion cycles.

IO-SS50-6802 bill of materials (BOM)

1 components, 1 distinct parts.

QtyPartRefs
1
SS50-6800
CN1

IO-SS50-6802 design files

The KiCad project lives in the crsjones/68Retro repository on GitHub; these links point at the commit this page was built from.

IO-SS50-6802: common questions

How big is the IO-SS50-6802 PCB?

The IO-SS50-6802 measures 152.4 × 66 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the IO-SS50-6802?

1 components, from 1 distinct parts. The full bill of materials is listed on this page.

Where can I download the IO-SS50-6802 design files?

From the crsjones/68Retro repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the IO-SS50-6802 design in my own project?

Yes, under the terms of its GPL-3.0 license, which crsjones chose for the repository.

Similar boards