RSdB

cw-urn·RSdB·pcb/rsdb_rev1.kicad_pcb

RSdB PCB layout, top view — open source board by cw-urn

About the RSdB PCB

RSdB is an open source PCB design by cw-urn, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 30 × 60 mm, with 10 components from 7 distinct parts.

Other key parts include the MSM261DGT003 and MCU_SEEED_XIAO_RP2040. By type, the board carries 4 resistors, 2 ICs, 2 diodes, 1 connector and 1 capacitor.

It belongs with the displays & leds designs in this gallery.

From the project

General usage dB meter with an OLED display.

The microphone I chose doesn't send traditional audio signals, instead it sends a single stream of ones and zeros at roughly 2 MHz. So one bit per clock pulse. The important part here is that stream having a bunch of repeating numbers after another.

If it sends a bunch of ones, then the sound pressure is high, and sends a bunch of zeros when it's low. The XIAO generates the clock, and reads the DATA pin at the same time. Once enough bits have accumulated, a decimation filter takes over, and it applies a low-pass sinc filter across every 128 bits and collapses them into a single 16-bit PCM…

RSdB, from the project README
From the project README

Main components on the RSdB

RSdB bill of materials (BOM)

10 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
MSM261DGT003
U1
1
MCU_SEEED_XIAO_RP2040
MCU_Seeed_XIAO_RP2040
U2
1
OLED_128X64
OLED_128x64
J1
2
PESD5V0F1BL
D1, D2
1
0.1UF
0.1uF
C1
2
4.7K
4.7k
R1, R2
2
30
R3, R4

RSdB design files

The KiCad project lives in the cw-urn/RSdB repository on GitHub; these links point at the commit this page was built from.

RSdB: common questions

How big is the RSdB PCB?

The RSdB measures 30 × 60 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the RSdB?

10 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the RSdB design files?

From the cw-urn/RSdB repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the RSdB design in my own project?

Yes, under the terms of its GPL-3.0 license, which cw-urn chose for the repository.

Similar boards