HardLabs

Board

DATX02-19-04·board·devel/devel.kicad_pcb

Board layout, top view — open source AVR/Arduino board by DATX02-19-04

About the Board

Board is an open source AVR/Arduino PCB design by DATX02-19-04, published on GitHub. It is a 2-layer board measuring 93.3 × 42.7 mm, with 64 components from 8 distinct parts.

Its main chip is the Arduino_UNO_R3, from the AVR/Arduino family. By type, the board carries 23 resistors, 16 capacitors, 15 switches, 8 diodes and 1 module.

Main components on the Board

Arduino_UNO_R3

Board bill of materials (BOM)

64 components, 8 distinct parts.

QtyPartRefs
1
Arduino_UNO_R3
A1
1
R_POT
RV1
15
SW
SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8 +7
8
LED
D1, D2, D3, D4, D5, D6, D7, D8
15
10n
C1, C2, C3, C4, C5, C6, C7, C8 +7
1
C
C13
15
10k
R1, R2, R3, R4, R5, R6, R7, R8 +7
8
R
R15, R16, R17, R18, R19, R20, R21, R22

Board design files

The KiCad project lives in the DATX02-19-04/board repository on GitHub; these links point at the commit this page was built from.

Board: common questions

What microcontroller does the Board use?

The Board is built around the Arduino_UNO_R3, from the AVR/Arduino family.

How big is the Board?

The Board measures 93.3 × 42.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Board?

64 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Board design files?

From the DATX02-19-04/board repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Board design in my own project?

The repository has no license, so all rights stay with DATX02-19-04. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Board without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards