SimpleServoCtrl32

DavidMFlynn·SimpleServoCtrl32·SimpleServoPCB32/SimpleServoCtrl32.kicad_pcb

SimpleServoCtrl32 PCB layout, top view — open source PIC board by DavidMFlynn

About the SimpleServoCtrl32 PCB

SimpleServoCtrl32 is an open source PIC PCB design by DavidMFlynn, published on GitHub. It is a 2-layer board measuring 49.5 × 96.5 mm, with 75 components from 17 distinct parts.

Its main chip is the PIC16F1847, from the PIC family. Other key parts include the 74LS237. By type, the board carries 41 resistors, 15 connectors, 6 capacitors, 5 ICs, 4 diodes and 3 switches.

It belongs with the robotics & motion designs in this gallery.

From the project

PIC16F1847 based R/C servo controller, 32 channel.

Main components on the SimpleServoCtrl32

PIC16F184774LS237

SimpleServoCtrl32 bill of materials (BOM)

75 components, 17 distinct parts.

QtyPartRefs
1
PIC16F1847
U1
4
74LS237
U2, U3, U4, U5
12
CONN_8
P1A1, P1B1, P1C1, P2A1, P2B1, P2C1, P3A1, P3B1 +4
1
Power
P5
1
I2C
P6
1
CONN_01X05
P7
3
SW_PUSH
SW1, SW2, SW3
1
78L05
VR1
3
LED
D1, D2, D3
1
DIODE
D4
1
220uF
C1
1
2.2uF
C2
4
0.1uF
C3, C4, C5, C6
32
220Ω
R1, R2, R3, R4, R5, R6, R7, R8 +24
3
470Ω
R17, R19, R21
4
47KΩ
R18, R20, R22, R41
2
4.7KΩ
R23, R24

SimpleServoCtrl32 design files

The KiCad project lives in the DavidMFlynn/SimpleServoCtrl32 repository on GitHub; these links point at the commit this page was built from.

SimpleServoCtrl32: common questions

What microcontroller does the SimpleServoCtrl32 use?

The SimpleServoCtrl32 is built around the PIC16F1847, from the PIC family.

How big is the SimpleServoCtrl32 PCB?

The SimpleServoCtrl32 measures 49.5 × 96.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the SimpleServoCtrl32?

75 components, from 17 distinct parts. The full bill of materials is listed on this page.

Where can I download the SimpleServoCtrl32 design files?

From the DavidMFlynn/SimpleServoCtrl32 repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the SimpleServoCtrl32 design in my own project?

The repository has no license, so all rights stay with DavidMFlynn. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the SimpleServoCtrl32 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug PIC firmware against it before you order a PCB.

Similar boards