Anemometer
derGraph·anemometer·KiCad/anemometer/anemometer.kicad_pcb
About the Anemometer PCB
Anemometer is an open source PCB design by derGraph, published on GitHub. It is a 2-layer board measuring 52 × 26 mm, with 16 components from 8 distinct parts.
Other key parts include the LM324 and LM393. By type, the board carries 10 resistors, 3 ICs and 1 capacitor.
From the project
My Anemometer Design for MCU, probably with ESP8266 Code soon
This project contains the circuit and code for a ultrasonic Anemometer. The anemometer works by 4 ultrasonic Transducers where 2 of them always face each other. 2 Transducers describe one Axis, so with 4 Transducers you can measure x and y Wind components. The circuit only recieves the signal and boosts a Peak-to-Peak Sine Voltage of 50mV to a Square Wave of VCC to 0V. With the microcontroller you have to compare the time difference between the output signal, a signal of 50% Duty Cycle 40kHz and the recieved signal. Then you can calibrate your sensor with 0 wind speed. In my case i measure…

Main components on the Anemometer
Anemometer bill of materials (BOM)
16 components, 8 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Conn_01x04 | JST_SH_SM04B-SRSS-TB_1x04-1MP_P1.00mm_Horizontal | MCU1 |
| 1 | LM324 | SOIC-14_3.9x8.7mm_P1.27mm | U1 |
| 1 | LM393 | SOIC-8_3.9x4.9mm_P1.27mm | U2 |
| 1 | Ultrasound_1 | JST_SH_SM02B-SRSS-TB_1x02-1MP_P1.00mm_Horizontal | Spkr1 |
| 1 | Ultrasound_2 | JST_SH_SM02B-SRSS-TB_1x02-1MP_P1.00mm_Horizontal | Spkr2 |
| 1 | .1uF | C_0805_2012Metric_Pad1.18x1.45mm_HandSolder | C1 |
| 6 | 1k | R_0805_2012Metric_Pad1.20x1.40mm_HandSolder | R1, R2, R4, R5, R10, R11 |
| 4 | 10k | R_0805_2012Metric_Pad1.20x1.40mm_HandSolder | R3, R6, R9, R13 |
Anemometer design files
The KiCad project lives in the derGraph/anemometer repository on GitHub; these links point at the commit this page was built from.
Anemometer: common questions
How big is the Anemometer PCB?
The Anemometer measures 52 × 26 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Anemometer?
16 components, from 8 distinct parts. The full bill of materials is listed on this page.
Where can I download the Anemometer design files?
From the derGraph/anemometer repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Anemometer design in my own project?
The repository has no license, so all rights stay with derGraph. Use it as a reference, and ask the author before reusing the design.