Rotary Encoders
dgdimick·ARC-210-DCS-Display·PCBs/Rotary Encoders/Rotary Encoders.kicad_pcb
About the Rotary Encoders PCB
Rotary Encoders is an open source PCB design by dgdimick, published on GitHub. It is a 2-layer board measuring 45.7 × 108.8 mm, with 7 components from 2 distinct parts.
By type, the board carries 6 switches and 1 connector.
It belongs with the rf & radio and displays & leds designs in this gallery.
From the project
DIY ARC-210 radio panel for DCS A-10C II using DCSBIOS (DCS-BIOS), Teensy 4.1 and an ILI9488 TFT, with firmware, PCB designs and printable parts.
Version 1.3, updated October 11, 2026. KiCad 10 project.
I made minor changes to the PCB for version 1.3. This version retains the corrected power GND connections and replaces the previously published project. Use version 1.3 for new builds and manufacturing exports.
I have checked this six-encoder PCB against its schematic. The electrical check reported zero errors and warnings; the PCB check reported zero violations, zero unconnected pads and zero schematic parity issues under the project's saved check settings. Courtyard and certain footprint checks are disabled in those settings.
Rotary Encoders bill of materials (BOM)
7 components, 2 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Conn_01x14_Pin | PinHeader_1x14_P2.54mm_Vertical | J1 |
| 6 | RotaryEncoder_Switch | PEC11H4220FS0024 | SW1, SW2, SW3, SW4, SW5, SW6 |
Rotary Encoders design files
The KiCad project lives in the dgdimick/ARC-210-DCS-Display repository on GitHub; these links point at the commit this page was built from.
Rotary Encoders: common questions
How big is the Rotary Encoders PCB?
The Rotary Encoders measures 45.7 × 108.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Rotary Encoders?
7 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Rotary Encoders design files?
From the dgdimick/ARC-210-DCS-Display repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Rotary Encoders design in my own project?
The repository has no license, so all rights stay with dgdimick. Use it as a reference, and ask the author before reusing the design.
More boards in ARC-210-DCS-Display
Similar boards
BM28B0.6-24DSBreakout
scottbez1
15.2 × 35.6 mm3 parts2LApache-2.022.2kLevelShifterBreakout
scottbez1
15.2 × 20.3 mm5 parts2LApache-2.022.2kView base
scottbez1
81.2 × 81.2 mm81 parts2LApache-2.022.2kView screen
scottbez1
35 × 35 mm12 parts2LApache-2.022.2kDisplay eval
byrantech
52.1 × 22.6 mm12 parts4LMIT4.3kChainlinkBase
scottbez1
98.4 × 190.5 mm119 parts2LApache-2.04.2k