Mesh

dholth·mesh·talkclock/talkclock.kicad_pcb

Mesh PCB layout, top view — open source STM32 board by dholth

About the Mesh PCB

Mesh is an open source STM32 PCB design by dholth, published on GitHub. It is a 2-layer board measuring 50 × 50 mm, with 50 components from 32 distinct parts.

Its main chip is the STM32F051CxT6, from the STM32 family. Other key parts include the PAM8301, nRF24p and MCP1700T-3302E/MB. By type, the board carries 15 capacitors, 13 connectors, 8 resistors, 4 ICs, 2 jumpers and 2 diodes.

Main components on the Mesh

STM32F051CxT6PAM8301nRF24pMCP1700T-3302E/MB

Mesh bill of materials (BOM)

50 components, 32 distinct parts.

QtyPartRefs
1
STM32F051CxT6
U1
1
PAM8301
U2
1
nRF24p
U3
1
MCP1700T-3302E/MB
U4
1
Q_NMOS_GSD
Q2
1
SMD_CRYSTAL
X1
1
ST-USB-001G
J1
2
CONN_01X02
P1, P13
2
CONN_01X02
P2, P3
1
CONN_02X01
P4
1
CONN_02X01
P5
1
STM32_DEBUG
P6
2
CONN_01X04
P7, P8
1
CONN_01X11
P11
2
TEST_1P
P14, P15
1
FUSE
F1
2
JUMPER
JP1, JP2
1
POT
RV1
1
E_SWITCH
SW1
1
CLV1A
D1
Show 12 more
QtyPartRefs
1
1N4448
D2
1
BLM18PG221
L1
2
10nF
C1, C11
6
1uF
C2, C4, C7, C12, C13, C14
3
100nF
C3, C9, C10
2
DNP
C5, C6
1
4.7uF
C8
1
10uF
C15
1
68
R1
1
100
R2
4
1M
R3, R4, R5, R8
2
5.6
R6, R7

Mesh design files

The KiCad project lives in the dholth/mesh repository on GitHub; these links point at the commit this page was built from.

Mesh: common questions

What microcontroller does the Mesh use?

The Mesh is built around the STM32F051CxT6, from the STM32 family.

How big is the Mesh PCB?

The Mesh measures 50 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Mesh?

50 components, from 32 distinct parts. The full bill of materials is listed on this page.

Where can I download the Mesh design files?

From the dholth/mesh repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Mesh design in my own project?

The repository has no license, so all rights stay with dholth. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Mesh without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards