HardLabs

Ir clone

dilshan·ir-clone·design/ir-signalgen-lite.kicad_pcb

Ir clone PCB layout, top view — open source STM32 board by dilshan

About the Ir clone PCB

Ir clone is an open source STM32 PCB design by dilshan, published on GitHub under the MIT license. It is a 2-layer board measuring 32.1 × 41.2 mm, with 35 components from 26 distinct parts.

Its main chip is the STM8S003F3P, from the STM32 family. Other key parts include the AMS1117-3.3, TSOP1838 and 24LC32. By type, the board carries 10 capacitors, 10 resistors, 4 ICs, 4 connectors, 2 transistors and 2 jumpers.

From the project

Open-source infrared remote control signal analysis and generating tool

IR Remote Control Clone Utility ===============================

IR Clone is an open-source infrared remote control signal analysis and generating tool. This utility can clone IR signals, examine the IR remote control signals, and modify or create new IR signals.

This project consists of both hardware and software utilities. The hardware module contains an 8-bit MCU, 32Kbit EEPROM, IR receiver, and transmitter.

Ir clone, from the project README
From the project README

Main components on the Ir clone

AMS1117-3.3STM8S003F3PTSOP183824LC32

Ir clone bill of materials (BOM)

35 components, 26 distinct parts.

QtyPartRefs
1
AMS1117-3.3
U101
1
STM8S003F3P
U201
1
TSOP1838
U301
1
24LC32
U302
2
MMBT3904
Q301, Q302
1
DC-IN
J101
1
BAT-IN
J102
1
ICP
J201
1
KEYMATRIX
J202
1
PWR-SRC
JP101
1
MODE
JP202
1
60-2S1M
SW201
1
LD271
D301
1
GREEN-3mm
D302
1
10MFD
C101
6
0.1MFD
C102, C103, C202, C204, C301, C302
1
4.7MFD
C104
1
1MFD
C201
1
1MFD
C203
2
10K
R201, R303
Show 6 more
QtyPartRefs
1
1K
R202
3
4.7K
R301, R302, R305
1
22K
R304
1
56R
R306
1
470R
R307
1
22K
RN201

Ir clone design files

The KiCad project lives in the dilshan/ir-clone repository on GitHub; these links point at the commit this page was built from.

Ir clone: common questions

What microcontroller does the Ir clone use?

The Ir clone is built around the STM8S003F3P, from the STM32 family.

How big is the Ir clone PCB?

The Ir clone measures 32.1 × 41.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ir clone?

35 components, from 26 distinct parts. The full bill of materials is listed on this page.

Where can I download the Ir clone design files?

From the dilshan/ir-clone repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Ir clone design in my own project?

Yes, under the terms of its MIT license, which dilshan chose for the repository.

Can I test firmware for the Ir clone without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards