Knob board

doug7410·nowplaying-appliance·hardware/knob-board/knob-board.kicad_pcb

Knob board layout, top view — open source board by doug7410

About the Knob board

Knob board is an open source PCB design by doug7410, published on GitHub under the MIT license. It is a 2-layer board measuring 100 × 30 mm, with 3 components from 3 distinct parts.

By type, the board carries 2 resistors and 1 connector.

It belongs with the displays & leds and test & measurement designs in this gallery.

From the project

Build guide, BOM and hardware for the Now-Playing desk appliance: HUB75 spectrum + touch now-playing display driven by room-mic song recognition

The Board-1 front-panel knob PCB: three EC11 rotary encoders (MODE / BRIGHT / GAIN) plus a switch resistor ladder, out to a single 8-pin JST-XH connector.

This is a re-creation in KiCad of the design that was routed in Flux (https://www.flux.ai/doug7410/nowplaying-knob-board~ss). Flux cannot export .kicadpcb/.kicadsch — only Gerbers, IPC-2581, ODB++, GenCAD and EDIF, none of which KiCad imports — so the schematic and layout were rebuilt from the Flux Gerber and IPC-D-356 netlist exports. The KiCad files here are now the source of truth.

Knob board bill of materials (BOM)

3 components, 3 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
B8B-XH-A(LF)(SN)
Conn_01x08
J1
1
C61299
3.3k
R1
1
C61299
10k
R2

Knob board design files

The KiCad project lives in the doug7410/nowplaying-appliance repository on GitHub; these links point at the commit this page was built from.

Knob board: common questions

How big is the Knob board?

The Knob board measures 100 × 30 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Knob board?

3 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Knob board design files?

From the doug7410/nowplaying-appliance repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Knob board design in my own project?

Yes, under the terms of its MIT license, which doug7410 chose for the repository.

More boards in nowplaying-appliance

Similar boards