HardLabs

MicArray

dylanzodrow·Aerial_Drone_Tracking·Kicad3/MicArray.kicad_pcb

MicArray PCB layout, top view — open source AVR/Arduino board by dylanzodrow

About the MicArray PCB

MicArray is an open source AVR/Arduino PCB design by dylanzodrow, published on GitHub. It is a 2-layer board measuring 183.4 × 183.4 mm, with 74 components from 10 distinct parts.

Its main chip is the ArduinoLike, from the AVR/Arduino family. Other key parts include the SN74HC138. By type, the board carries 25 jumpers, 24 diodes, 9 capacitors, 6 resistors, 1 IC and 1 connector.

It belongs with the robotics & motion designs in this gallery.

Main components on the MicArray

SN74HC138

MicArray bill of materials (BOM)

74 components, 10 distinct parts.

QtyPartRefs
1
SN74HC138
U2
1
Conn_01x12_Male
J1
25
Jumper
JP1, JP2, JP3, JP4, JP5, JP6, JP7, JP8 +17
8
ICS-52000
Mic1, Mic2, Mic3, Mic4, Mic5, Mic6, Mic7, Mic8
24
LED
D1, D2, D3, D4, D5, D6, D7, D8 +16
8
.1u
C1, C2, C3, C4, C5, C6, C7, C8
1
10uF
C9
2
1k
R1, R2
3
100
R3, R9, R11
1
100k
R4

MicArray design files

The KiCad project lives in the dylanzodrow/Aerial_Drone_Tracking repository on GitHub; these links point at the commit this page was built from.

MicArray: common questions

What microcontroller does the MicArray use?

The MicArray is built around the ArduinoLike, from the AVR/Arduino family.

How big is the MicArray PCB?

The MicArray measures 183.4 × 183.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the MicArray?

74 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the MicArray design files?

From the dylanzodrow/Aerial_Drone_Tracking repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the MicArray design in my own project?

The repository has no license, so all rights stay with dylanzodrow. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the MicArray without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Aerial_Drone_Tracking

Similar boards