HardLabs

Dual CamCon

EasternEdgeRobotics·Electrical_2019·PCBs/Dual CamCon/Dual CamCon.kicad_pcb

Dual CamCon PCB layout, top view — open source Raspberry Pi board by EasternEdgeRobotics

About the Dual CamCon PCB

Dual CamCon is an open source Raspberry Pi PCB design by EasternEdgeRobotics, published on GitHub under the MIT license. It is a 2-layer board measuring 56 × 65 mm, with 11 components from 5 distinct parts.

Its main chip is the Raspberry Pi GPIO, from the Raspberry Pi family. By type, the board carries 7 connectors and 4 capacitors.

From the project

Repository for holding PCB designs, Pspice files, and other shocking thigns!

Looking for documentation? See the wiki.

Looking for control software? See the 2019 repo.

Dual CamCon bill of materials (BOM)

11 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
Servo Input
J1, J2
2
Camera In
J3, J4
1
Raspberry Pi GPIO
J5
2
HDMI Out
P1, P2
4
C
C1, C2, C3, C4

Dual CamCon design files

The KiCad project lives in the EasternEdgeRobotics/Electrical_2019 repository on GitHub; these links point at the commit this page was built from.

Dual CamCon: common questions

What microcontroller does the Dual CamCon use?

The Dual CamCon is built around the Raspberry Pi GPIO, from the Raspberry Pi family.

How big is the Dual CamCon PCB?

The Dual CamCon measures 56 × 65 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Dual CamCon?

11 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Dual CamCon design files?

From the EasternEdgeRobotics/Electrical_2019 repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Dual CamCon design in my own project?

Yes, under the terms of its MIT license, which EasternEdgeRobotics chose for the repository.

Can I test firmware for the Dual CamCon without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Raspberry Pi firmware against it before you order a PCB.

More boards in Electrical_2019

Similar boards