Needforheat p1-base hardware

energietransitie·needforheat-p1-base-hardware·pcb/needforheat-p1-base-hardware.kicad_pcb

Needforheat p1-base hardware PCB layout, top view — open source board by energietransitie

About the Needforheat p1-base hardware PCB

Needforheat p1-base hardware is an open source PCB design by energietransitie, published on GitHub under the CERN-OHL-P-2.0 license. It is a 2-layer board measuring 51 × 36 mm, with 22 components from 15 distinct parts.

Other key parts include the 74HC14D,653 and EL357N-G. By type, the board carries 7 resistors, 5 diodes, 3 transistors, 3 connectors, 2 ICs and 1 switch.

From the project

Open hardware design files for the NeedForHeat P1-BASE extension module that allows an M5Stack CoreInk to read data from DSMR-compliant smart meters via the P1 port

This repository contains the open hardware design files for the NeedForHeat P1-BASE device, which can be used as a CoreInk BASE extension module, on the back of an M5Stack CoreInk device.

The NeedForHeat P1-BASE enables reading smart meters that adhere to the Dutch Smart Meter Requirements via the P1 port.

For the associated firmware that you can run on this device, please see this repository.

Needforheat p1-base hardware, from the project README
From the project README

Main components on the Needforheat p1-base hardware

Needforheat p1-base hardware bill of materials (BOM)

22 components, 15 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
74HC14D,653
IC1
1
EL357N-G
U1
1
MMBT3904
Q1
1
MMBT5401
Q2
1
TBC847_E_20160525
Q3
1
CONN_02X08_COUNTER_CLOCKWISE
Conn_02x08_Counter_Clockwise
J1
2
RJ12
J2, J3
1
KF1001-03P-R0-GL-DFT-01B
SW1
5
1N5819WS
D1, D2, D3, D4, D5
1
C49678
C_Small
C1
2
2K2
2k2
R1, R4
2
1k
R2, R3
1
680
R5
1
10K
10k
R6
1
0
R7

Needforheat p1-base hardware design files

The KiCad project lives in the energietransitie/needforheat-p1-base-hardware repository on GitHub; these links point at the commit this page was built from.

Needforheat p1-base hardware: common questions

How big is the Needforheat p1-base hardware PCB?

The Needforheat p1-base hardware measures 51 × 36 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Needforheat p1-base hardware?

22 components, from 15 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Needforheat p1-base hardware design files?

From the energietransitie/needforheat-p1-base-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Needforheat p1-base hardware design in my own project?

Yes, under the terms of its CERN-OHL-P-2.0 license, which energietransitie chose for the repository.