CH340c usb uart board

Evans-Kwashie·CH340c-usb-uart-board

CH340c usb uart board layout, top view — open source board by Evans-Kwashie

About the CH340c usb uart board

CH340c usb uart board is an open source PCB design by Evans-Kwashie, published on GitHub under the CERN-OHL-S-2.0 license. It is a 2-layer board measuring 18 × 35.5 mm, with 6 components from 4 distinct parts.

By type, the board carries 3 capacitors and 2 resistors.

It belongs with the usb & debug tools designs in this gallery.

From the project

2-layer USB-C to TTL UART adapter PCB using the CH340C USB-to-serial bridge, with USB-C CC resistors, VBUS decoupling and a 4-pin UART header.

A 2-layer PCB that bridges USB-C to a TTL UART interface, built from scratch in KiCad using the CH340C USB-to-serial chip. Designed as a self-directed learning project to understand USB-C connector requirements, UART fundamentals, and full-cycle PCB design (schematic, layout, routing, and DRC resolution).

This board allows a computer to communicate with a microcontroller or other UART-based device over USB-C, exposing TX, RX, GND, and VCC on a simple header. It replaces the need for a legacy USB-A to serial adapter with a compact, modern USB-C native solution.

CH340c usb uart board, from the project README
From the project README

CH340c usb uart board bill of materials (BOM)

6 components, 4 distinct parts.

QtyPartRefs
1
CH340C
CH340C
2
0.1uF
C1, C2
1
10uF
C3
2
5.1K
R1, R2

CH340c usb uart board design files

The KiCad project lives in the Evans-Kwashie/CH340c-usb-uart-board repository on GitHub; these links point at the commit this page was built from.

CH340c usb uart board: common questions

How big is the CH340c usb uart board?

The CH340c usb uart board measures 18 × 35.5 mm, has 2 copper layers and is 1.600198 mm thick.

How many components are on the CH340c usb uart board?

6 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the CH340c usb uart board design files?

From the Evans-Kwashie/CH340c-usb-uart-board repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the CH340c usb uart board design in my own project?

Yes, under the terms of its CERN-OHL-S-2.0 license, which Evans-Kwashie chose for the repository.

Similar boards