HardLabs

Code

evyd13·wasdat·wasdat-code/code.kicad_pcb

Code PCB layout, top view — open source AVR/Arduino board by evyd13
Simulate this board

About the Code PCB

Code is an open source AVR/Arduino PCB design by evyd13, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 55.5 × 33 mm, with 29 components from 15 distinct parts.

Its main chip is the ATMEGA32U4-AU, from the AVR/Arduino family. Other key parts include the 74HC138D. By type, the board carries 16 resistors, 5 capacitors, 2 ICs, 1 transistor, 1 crystal and 1 connector.

From the project

Controller for WASD V2/CODE

Main components on the Code

ATMEGA32U4-AU74HC138D

Code bill of materials (BOM)

29 components, 15 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ATMEGA32U4-AU
ATmega32U4
Microchip Tech
U1
1
74HC138D
74HC138
Nexperia
U2
1
AO3400
Q1
1
CSTNE16M0V530000R0
16mhz
Murata Electronics
X1
1
ISP
J1
1
TLC-PSMD050
Polyfuse
TLC Electronic
F1
1
Left
H1
1
Right
H2
3
CL10B104KO8NNNC
0.1u
Samsung Electro-Mechanics
C1, C2, C3
1
CL21A475KAQNNNE
4.7u
Samsung Electro-Mechanics
C4
1
CL10A105KP8NNNC
1u
Samsung Electro-Mechanics
C5
2
WR06X220JTL
22
Walsin Tech Corp
R1, R2
3
WR06X103JTL
10k
Walsin Tech Corp
R3, R4, R5
3
1k
R6, R7, R8
8
ERJP06J750V
75
PANASONIC
R9, R10, R11, R12, R13, R14, R15, R16

Code design files

The KiCad project lives in the evyd13/wasdat repository on GitHub; these links point at the commit this page was built from.

Code: common questions

What microcontroller does the Code use?

The Code is built around the ATMEGA32U4-AU, from the AVR/Arduino family.

How big is the Code PCB?

The Code measures 55.5 × 33 mm, has 2 copper layers and is 1.2 mm thick.

How many components are on the Code?

29 components, from 15 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Code design files?

From the evyd13/wasdat repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Code design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which evyd13 chose for the repository.

Can I test firmware for the Code without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in wasdat

Similar boards