Snes-Ctr

f0gger·Snes-Ctr

Snes-Ctr PCB layout, top view — open source AVR/Arduino board by f0gger

About the Snes-Ctr PCB

Snes-Ctr is an open source AVR/Arduino PCB design by f0gger, published on GitHub. It is a 2-layer board measuring 120.5 × 59 mm, with 5 components from 5 distinct parts.

Its main chip is the ATmega328-P, from the AVR/Arduino family.

From the project

KiCad hardware design files for a custom Super Nintendo Entertainment System (SNES) controller built around the ATmega328P microcontroller, with I²C communication for interfacing with external devices.

KiCad hardware design files for a custom Super Nintendo Entertainment System (SNES) controller built around the ATmega328P microcontroller, with I²C communication for interfacing with external devices.

File names and structure may vary depending on the actual project files. Hardware Overview

The controller uses the ATmega328P to interface with the SNES controller inputs and handle communication with external hardware over the I²C bus.

Main components on the Snes-Ctr

Snes-Ctr bill of materials (BOM)

5 components, 5 distinct parts.

QtyPartRefs
1
ATmega328-P
U1
1
4.7k
4.7k
1
10k
10k
1
100n
100n
1
680
680

Snes-Ctr design files

The KiCad project lives in the f0gger/Snes-Ctr repository on GitHub; these links point at the commit this page was built from.

Snes-Ctr: common questions

What microcontroller does the Snes-Ctr use?

The Snes-Ctr is built around the ATmega328-P, from the AVR/Arduino family.

How big is the Snes-Ctr PCB?

The Snes-Ctr measures 120.5 × 59 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Snes-Ctr?

5 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Snes-Ctr design files?

From the f0gger/Snes-Ctr repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Snes-Ctr design in my own project?

The repository has no license, so all rights stay with f0gger. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Snes-Ctr without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards