SerPlus shield for the bat board
About the SerPlus shield for the bat board
SerPlus shield for the bat board is an open source PCB design by flabbergast, published on GitHub under the BSD-3-Clause license. It is a 2-layer board measuring 31.8 × 17.8 mm, with 15 components from 10 distinct parts.
By type, the board carries 7 resistors, 2 connectors, 2 switches, 1 transistor, 1 LED and 1 diode.
It belongs with the keyboards and dev boards & breakouts designs in this gallery.
From the project
flabbergast's kicad files
This is a PCB for a 45% keyboard. Supports ALPS and Cherry MX switches. No LEDs, only one SMT LED on the front bottom side. The supported layouts are this and this.
The controller MCU is STM32F042K6T7 - 32kB flash, 6kB RAM, DFU bootloader in ROM, LQFP-32 package. The BOOT0 pin for entering the bootloader on power up is brought out to a pushbutton on the bottom side of the PCB.
SerPlus shield for the bat board bill of materials (BOM)
15 components, 10 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Q_PMOS_GSD | SOT-23_Handsoldering | Q1 |
| 1 | BOARD | M11_NOSILK | J1 |
| 1 | mount | M02_NOSILK | J3 |
| 1 | SW_Push | TACTILE-SWITCH-SMT-1101NE | SW1 |
| 1 | SW_SP3T | SW_SP3T_PCM13 | SW2 |
| 1 | WS2812B | LED_WS2812B-PLCC4 | LED1 |
| 1 | 1D4148 | D_SOD-323_HandSoldering | D1 |
| 1 | 0.1uF | 0805_wide | C1 |
| 3 | 10kR | 0805_wide | R1, R2, R7 |
| 4 | 390R | 0805_wide | R3, R4, R5, R6 |
SerPlus shield for the bat board design files
The KiCad project lives in the flabbergast/kicad repository on GitHub; these links point at the commit this page was built from.
SerPlus shield for the bat board: common questions
How big is the SerPlus shield for the bat board?
The SerPlus shield for the bat board measures 31.8 × 17.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the SerPlus shield for the bat board?
15 components, from 10 distinct parts. The full bill of materials is listed on this page.
Where can I download the SerPlus shield for the bat board design files?
From the flabbergast/kicad repository on GitHub, which has the KiCad layout; the links under Design files point to each one.
Can I use the SerPlus shield for the bat board design in my own project?
Yes, under the terms of its BSD-3-Clause license, which flabbergast chose for the repository.
byrantech
google