Minix box

frogshead·minix-box·hw/kicad/minix-box.kicad_pcb

Minix box PCB layout, top view — open source board by frogshead

About the Minix box PCB

Minix box is an open source PCB design by frogshead, published on GitHub. It is a 2-layer board measuring 50 × 20 mm, with 14 components from 9 distinct parts.

Other key parts include the F1C200S, W25Q128JVSIQ and SY8089AAAC. By type, the board carries 5 ICs, 2 crystals, 2 connectors, 2 switches and 2 diodes.

From the project

Minimal low-cost single-board computer that boots to a Linux console (Allwinner F1C200s). KiCad + JLCPCB.

A minimal, low-cost single-board computer that boots to a Linux console, built around the Allwinner F1C200s (ARM926EJ-S with MMU and 64 MB DDR stacked in-package, so the PCB has no external memory bus to route). Parts are sourced from LCSC and the board is fabricated + assembled at JLCPCB.

The kicad/ files are a scaffold, not a finished design: a valid empty project, an empty root schematic, an empty 2-layer board, and library tables pointing at kicad/libraries/. Schematic capture and PCB layout are done in the KiCad 8 GUI.

Main components on the Minix box

Minix box bill of materials (BOM)

14 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
F1C200S
Allwinner(全志)
U1
1
W25Q128JVSIQ
CH340N
Winbond
U2
1
W25Q128JVSIQ
W25Q128JVSIQTR
Winbond(华邦)
U3
2
SY8089AAAC
Silergy(矽力杰)
U4, U5
2
Crystal
Y1, Y2
2
USB_C_Receptacle_USB2.0_16P
J1, J2
1
TF-01A
韩国韩荣
Card1
2
SW_Push
SW1, SW2
2
LED
D1, D2

Minix box design files

The KiCad project lives in the frogshead/minix-box repository on GitHub; these links point at the commit this page was built from.

Minix box: common questions

How big is the Minix box PCB?

The Minix box measures 50 × 20 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Minix box?

14 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Minix box design files?

From the frogshead/minix-box repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Minix box design in my own project?

The repository has no license, so all rights stay with frogshead. Use it as a reference, and ask the author before reusing the design.