Main

gabbla·xmas22_hw·production/main/main.kicad_pcb

Main PCB layout, top view — open source PIC board by gabbla

About the Main PCB

Main is an open source PIC PCB design by gabbla, published on GitHub. It is a 2-layer board measuring 60 × 69.5 mm, with 20 components from 8 distinct parts.

Its main chip is the PIC16F18044-I/ML, from the PIC family. By type, the board carries 8 resistors, 7 diodes, 1 IC, 1 connector, 1 battery holder and 1 switch.

Main components on the Main

PIC16F18044-I/ML

Main bill of materials (BOM)

20 components, 8 distinct parts.

QtyPartRefs
1
PIC16F18044-I/ML
PIC16F18044-I_ML
IC1
1
Main Side
J2
1
CR2032
BT1
1
SW_Push
SW1
7
LED
D9, D10, D11, D12, D14, D15, D16
1
100n
C1
1
47k
R9
7
R_Small
R10, R11, R12, R13, R15, R16, R17

Main design files

The KiCad project lives in the gabbla/xmas22_hw repository on GitHub; these links point at the commit this page was built from.

Main: common questions

What microcontroller does the Main use?

The Main is built around the PIC16F18044-I/ML, from the PIC family.

How big is the Main PCB?

The Main measures 60 × 69.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Main?

20 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Main design files?

From the gabbla/xmas22_hw repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Main design in my own project?

The repository has no license, so all rights stay with gabbla. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Main without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug PIC firmware against it before you order a PCB.

More boards in xmas22_hw

Similar boards