Movement control

GaryBlackbourne·raspberry-robot·pcbs/movement-control/movement-control.kicad_pcb

Movement control PCB layout, top view — open source STM32 board by GaryBlackbourne

About the Movement control PCB

Movement control is an open source STM32 PCB design by GaryBlackbourne, published on GitHub. It is a 4-layer board measuring 91.4 × 63.5 mm, with 45 components from 25 distinct parts.

Its main chip is the STM32F103C8Tx, from the STM32 family. Other key parts include the BD6220F-E2 and TMC2208_module. By type, the board carries 15 resistors, 12 capacitors, 11 connectors, 3 ICs, 2 switches and 1 module.

It belongs with the robotics & motion designs in this gallery.

Main components on the Movement control

BD6220F-E2STM32F103C8TxTMC2208_module

Movement control bill of materials (BOM)

45 components, 25 distinct parts.

QtyPartRefs
2
BD6220F-E2
U1, U2
1
STM32F103C8Tx
U3
1
TMC2208_module
A1
1
CONN_SERVO_RIGHT
J1
1
CONN_SERVO_LEFT
J2
1
SENSOR_CONNECTOR_1
J4
1
RASPBERRY_CONNECTOR
J5
1
SENSOR_CONNECTOR_2
J6
1
PWR_input
J7
1
SENSOR_CONNECTOR_3
J8
1
SENSOR_CONNECTOR_4
J9
1
DEBUG_UART
J10
1
Stepper_motor_out
J11
1
SWD_CONNECTOR
J12
1
SW_RST
SW1
1
SW_BTN
SW2
1
LED
D1
7
100n
C1, C3, C4, C6, C7, C9, C12
4
47u
C2, C5, C10, C11
1
1u
C8
Show 5 more
QtyPartRefs
6
10k
R1, R2, R3, R4, R7, R8
2
100k
R5, R11
2
100
R6, R13
1
1k
R9
4
4.7k
R10, R12, R14, R15

Movement control design files

The KiCad project lives in the GaryBlackbourne/raspberry-robot repository on GitHub; these links point at the commit this page was built from.

Movement control: common questions

What microcontroller does the Movement control use?

The Movement control is built around the STM32F103C8Tx, from the STM32 family.

How big is the Movement control PCB?

The Movement control measures 91.4 × 63.5 mm, has 4 copper layers and is 4.69 mm thick.

How many components are on the Movement control?

45 components, from 25 distinct parts. The full bill of materials is listed on this page.

Where can I download the Movement control design files?

From the GaryBlackbourne/raspberry-robot repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Movement control design in my own project?

The repository has no license, so all rights stay with GaryBlackbourne. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Movement control without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in raspberry-robot

Similar boards