HardLabs

LEDBoardBasic

hacker-fab·stepper-v2-led·dlp4710evm-lc-via/LEDBoardBasic.kicad_pcb

LEDBoardBasic PCB layout, top view — open source board by hacker-fab

About the LEDBoardBasic PCB

LEDBoardBasic is an open source PCB design by hacker-fab, published on GitHub under the Custom license license. It is a 2-layer board measuring 27.2 × 15.6 mm, with 5 components from 2 distinct parts.

By type, the board carries 4 diodes and 1 connector.

It belongs with the robotics & motion designs in this gallery.

From the project

Hacker Fab V2 Stepper UV LED PCB

Supported projectors: DLPDLCR471TPEVM: the classic V2 projector DLP4710EVM-LC: experimental projector due to part shortage

"You can order it through your PCB manufacturer of choice (we used JLCPCB). However, note that the PCB is copper core. This is because the LEDs draw several amps of current in operation. To ensure that the PCB doesn't melt, you should use copper core to facilitate better heat flow."

LEDBoardBasic bill of materials (BOM)

5 components, 2 distinct parts.

QtyPartRefs
1
Molex 874381043
J1
4
LED
D1, D2, D3, D4

LEDBoardBasic design files

The KiCad project lives in the hacker-fab/stepper-v2-led repository on GitHub; these links point at the commit this page was built from.

LEDBoardBasic: common questions

How big is the LEDBoardBasic PCB?

The LEDBoardBasic measures 27.2 × 15.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the LEDBoardBasic?

5 components, from 2 distinct parts. The full bill of materials is listed on this page.

Where can I download the LEDBoardBasic design files?

From the hacker-fab/stepper-v2-led repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the LEDBoardBasic design in my own project?

It is published under Custom license, which limits how it may be reused; read the license before building on it.

More boards in stepper-v2-led

Similar boards