HardLabs

G800Interface

hwreverse·PCBDesignLectures·3_21_22/G800Interface/G800Interface.kicad_pcb

G800Interface PCB layout, top view — open source AVR/Arduino board by hwreverse

About the G800Interface PCB

G800Interface is an open source AVR/Arduino PCB design by hwreverse, published on GitHub under the BSD-3-Clause license. It is a 2-layer board measuring 46 × 39 mm, with 28 components from 21 distinct parts.

Its main chip is the ATMEGA328P-AU, from the AVR/Arduino family. By type, the board carries 15 resistors, 5 capacitors, 3 diodes, 2 connectors, 1 IC and 1 fuse.

From the project

PCB Design course projects

Main components on the G800Interface

ATMEGA328P-AU

G800Interface bill of materials (BOM)

28 components, 21 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ATMEGA328P-AU
FT232RL
U1
1
USB_C_RECEPTACLE_USB2.0
11pin G800 Conn.
J1
1
USB_C_Receptacle_USB2.0
J2
1
700MA
Polyfuse_Small
F1
1
PWR_LED
D1
1
TXLED
D2
1
RXLED
D3
1
Ferrite_Bead_Small
FB1
2
100NF
0.1uF
C1, C4
1
100NF
10nF
C2
1
10UF
10uF
C3
1
15PF
0.1uF
C5
2
4.7K
100R
R1, R2
2
5.1K
100R
R3, R4
1
2.2K
10R
R5
2
10K
5.1K
R6, R7
1
10K
10R
R8
3
10K
R9, R11, R12
1
100R
10K
R10
2
10K
560R
R13, R14
Show 1 more
QtyPartRefs
1
560R
R15

G800Interface design files

The KiCad project lives in the hwreverse/PCBDesignLectures repository on GitHub; these links point at the commit this page was built from.

G800Interface: common questions

What microcontroller does the G800Interface use?

The G800Interface is built around the ATMEGA328P-AU, from the AVR/Arduino family.

How big is the G800Interface PCB?

The G800Interface measures 46 × 39 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the G800Interface?

28 components, from 21 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the G800Interface design files?

From the hwreverse/PCBDesignLectures repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the G800Interface design in my own project?

Yes, under the terms of its BSD-3-Clause license, which hwreverse chose for the repository.

Can I test firmware for the G800Interface without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in PCBDesignLectures

Similar boards