HardLabs

Clone hero arduino

jaakkolilja·clone-hero-arduino·KiCad/clone-hero-arduino/clone-hero-arduino.kicad_pcb

Clone hero arduino PCB layout, top view — open source AVR/Arduino board by jaakkolilja

About the Clone hero arduino PCB

Clone hero arduino is an open source AVR/Arduino PCB design by jaakkolilja, published on GitHub. It is a 2-layer board measuring 60 × 60 mm, with 22 components from 4 distinct parts.

Its main chip is the Arduino_Nano_Every, from the AVR/Arduino family. By type, the board carries 12 test points, 9 resistors and 1 module.

From the project

This project allows an Arduino Nano (or Nano Every) to function as a 9-button guitar controller for Clone Hero. Since the standard Nano does not support native keyboard emulation (HID), this project uses a Python bridge to read serial data and simulate keyboard inputs with minima

This project allows an Arduino Nano (or Nano Every) to function as a 9-button guitar controller for Clone Hero. Since the standard Nano does not support native keyboard emulation (HID), this project uses a Python bridge to read serial data and simulate keyboard inputs with minimal latency.

1. Arduino: - Upload the provided code to your Arduino. - The baud rate is set to 115200 to ensure high-speed communication.

Main components on the Clone hero arduino

Arduino_Nano_Every

Clone hero arduino bill of materials (BOM)

22 components, 4 distinct parts.

QtyPartRefs
1
Arduino_Nano_Every
A1
12
TestPoint
TP1, TP2, TP3, TP4, TP5, TP6, TP7, TP8 +4
5
10k
R1, R2, R3, R4, R5
4
R
R6, R7, R8, R9

Clone hero arduino design files

The KiCad project lives in the jaakkolilja/clone-hero-arduino repository on GitHub; these links point at the commit this page was built from.

Clone hero arduino: common questions

What microcontroller does the Clone hero arduino use?

The Clone hero arduino is built around the Arduino_Nano_Every, from the AVR/Arduino family.

How big is the Clone hero arduino PCB?

The Clone hero arduino measures 60 × 60 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Clone hero arduino?

22 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the Clone hero arduino design files?

From the jaakkolilja/clone-hero-arduino repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Clone hero arduino design in my own project?

The repository has no license, so all rights stay with jaakkolilja. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Clone hero arduino without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards