HardLabs

NanoSwinSIDlives

jimbro1000·nanoSwinSIDlives

NanoSwinSIDlives PCB layout, top view — open source AVR/Arduino board by jimbro1000

About the NanoSwinSIDlives PCB

NanoSwinSIDlives is an open source AVR/Arduino PCB design by jimbro1000, published on GitHub under the CERN-OHL-P-2.0 license. It is a 2-layer board measuring 18 × 38.3 mm, with 14 components from 13 distinct parts.

Its main chip is the ATmega88PA-AU, from the AVR/Arduino family. Other key parts include the Program and CB3-3C-32M000000. By type, the board carries 6 resistors, 3 ICs, 1 connector, 1 diode and 1 capacitor.

From the project

Recreated schematics and pcb design for nano SwinSIDb

This project contains schematics and pcb design for the simple "nano SwinSID b", based on Swinkels original design. The hex code for programming the AtMega88 core is not included. You can find that at http://www.tolaemon.com/nss/ .

The schematics have been transcribed from those presented on that same page. The PCB design, while close to the original, is unique to this repository.

Main components on the NanoSwinSIDlives

ATmega88PA-AUProgramCB3-3C-32M000000

NanoSwinSIDlives bill of materials (BOM)

14 components, 13 distinct parts.

QtyPartRefs
1
ATmega88PA-AU
U1
1
Program
U3
1
CB3-3C-32M000000
U5
1
6581/8580
J1
1
01-14
host_lower1
1
15-28
host_upper1
1
LED
D1
1
0.1uF
C1
2
1K
R1, R3
1
240K
R2
1
2K2
R4
1
4K7
R5
1
330
R6

NanoSwinSIDlives design files

The KiCad project lives in the jimbro1000/nanoSwinSIDlives repository on GitHub; these links point at the commit this page was built from.

NanoSwinSIDlives: common questions

What microcontroller does the NanoSwinSIDlives use?

The NanoSwinSIDlives is built around the ATmega88PA-AU, from the AVR/Arduino family.

How big is the NanoSwinSIDlives PCB?

The NanoSwinSIDlives measures 18 × 38.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the NanoSwinSIDlives?

14 components, from 13 distinct parts. The full bill of materials is listed on this page.

Where can I download the NanoSwinSIDlives design files?

From the jimbro1000/nanoSwinSIDlives repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the NanoSwinSIDlives design in my own project?

Yes, under the terms of its CERN-OHL-P-2.0 license, which jimbro1000 chose for the repository.

Can I test firmware for the NanoSwinSIDlives without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards