HardLabs

Displace pf correction

kanzalhaqa·displace_pf_correction·Kicad/RPFC_V0A/RPFC_V0A.kicad_pcb

Displace pf correction PCB layout, top view — open source AVR/Arduino board by kanzalhaqa

About the Displace pf correction PCB

Displace pf correction is an open source AVR/Arduino PCB design by kanzalhaqa, published on GitHub. It is a 2-layer board measuring 73.1 × 128.7 mm, with 50 components from 9 distinct parts.

Its main chip is the Arduino_Nano_Every, from the AVR/Arduino family. Other key parts include the SIM800L. By type, the board carries 8 transistors, 8 switches, 8 diodes, 8 resistors, 1 IC and 1 module.

Displace pf correction, from the project README
From the project README

Main components on the Displace pf correction

SIM800LArduino_Nano_Every

Displace pf correction bill of materials (BOM)

50 components, 9 distinct parts.

QtyPartRefs
1
SIM800L
U1
1
Arduino_Nano_Every
A1
8
BC547
Q1, Q2, Q3, Q4, Q5, Q6, Q7, Q8
1
4pin_header
H1
9
1pin_header
H2, H3, H4, H5, H6, H7, H8, H9 +1
8
JQC-3FC(T73) DC5V
SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8
6
Terminal_block_2pos
TB1, TB2, TB3, TB4, TB5, TB6
8
1N4007
D1, D2, D3, D4, D5, D6, D7, D8
8
R0603_1k
R1, R2, R3, R4, R5, R6, R7, R8

Displace pf correction design files

The KiCad project lives in the kanzalhaqa/displace_pf_correction repository on GitHub; these links point at the commit this page was built from.

Displace pf correction: common questions

What microcontroller does the Displace pf correction use?

The Displace pf correction is built around the Arduino_Nano_Every, from the AVR/Arduino family.

How big is the Displace pf correction PCB?

The Displace pf correction measures 73.1 × 128.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Displace pf correction?

50 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Displace pf correction design files?

From the kanzalhaqa/displace_pf_correction repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Displace pf correction design in my own project?

The repository has no license, so all rights stay with kanzalhaqa. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Displace pf correction without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards