HardLabs

Gps-2022

ksurct·gps-2022·kicad/gpsv1.1/gpsv1.3.kicad_pcb

Gps-2022 PCB layout, top view — open source Raspberry Pi board by ksurct

About the Gps-2022 PCB

Gps-2022 is an open source Raspberry Pi PCB design by ksurct, published on GitHub. It is a 2-layer board measuring 200 × 120 mm, with 45 components from 14 distinct parts.

Its main chip is the RaspberryPiDebug, from the Raspberry Pi family. Other key parts include the ExternalBattery and 1×24. By type, the board carries 18 resistors, 4 ICs, 4 connectors, 4 switches, 4 LEDs and 1 antenna.

It belongs with the rf & radio designs in this gallery, and the repository also holds 2 earlier revisions of it.

From the project

The gps repo

Main components on the Gps-2022

ExternalBattery1×24

Gps-2022 bill of materials (BOM)

45 components, 14 distinct parts.

QtyPartRefs
1
ExternalBattery
U1
2
1×24
U2, U3
1
ExternalBattery
U4
4
XH-3AFemaleConnector
XH-3A1, XH-3A2, XH-3A3, XH-3A4
1
SMAAntennaMale
Ant1
4
SW_Push
B1, B2, B3, B4
1
BuckConverter(LM2596)
DC-DC1
1
RaspberryPiDebug
Debug1
1
PA1616D
PA1
1
RaspberryPi3
Rasp1
5
TOFSensor
TOF1, TOF2, TOF3, TOF4, TOF5
1
Teensy4.1
Teensy1
4
LED
LED1, LED2, LED3, LED4
18
R
R1, R2, R3, R4, R5, R6, R7, R8 +10

Gps-2022 design files

The KiCad project lives in the ksurct/gps-2022 repository on GitHub; these links point at the commit this page was built from.

Gps-2022: common questions

What microcontroller does the Gps-2022 use?

The Gps-2022 is built around the RaspberryPiDebug, from the Raspberry Pi family.

How big is the Gps-2022 PCB?

The Gps-2022 measures 200 × 120 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Gps-2022?

45 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Gps-2022 design files?

From the ksurct/gps-2022 repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Gps-2022 design in my own project?

The repository has no license, so all rights stay with ksurct. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Gps-2022 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Raspberry Pi firmware against it before you order a PCB.

Earlier revisions in the repo: gpsv1.2, gpsv1.1

Similar boards