HardLabs

Placa1

LEOSProyecdodegardo·Archivos-proyecto-de-grado

Placa1 PCB layout, top view — open source ESP32 board by LEOSProyecdodegardo

About the Placa1 PCB

Placa1 is an open source ESP32 PCB design by LEOSProyecdodegardo, published on GitHub. It is a 2-layer board measuring 66 × 61 mm, with 12 components from 10 distinct parts.

Its main chip is the ESP32-S2, from the ESP32 family. By type, the board carries 5 resistors, 1 switch and 1 diode.

From the project

este docuemnto

Placa1 bill of materials (BOM)

12 components, 10 distinct parts.

QtyPartRefs
1
~
ESP32-S2
1
GPS-15210
GPS1
1
D_Laser_1C2A
LD2
1
~
OPENLOG1
1
SW_DPDT_x2
SW2
1
~
VL53CX1
1
LED
D1
1
100
R4
2
100K
R5, R6
2
0
R7, R8

Placa1 design files

The KiCad project lives in the LEOSProyecdodegardo/Archivos-proyecto-de-grado repository on GitHub; these links point at the commit this page was built from.

Placa1: common questions

What microcontroller does the Placa1 use?

The Placa1 is built around the ESP32-S2, from the ESP32 family.

How big is the Placa1 PCB?

The Placa1 measures 66 × 61 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Placa1?

12 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Placa1 design files?

From the LEOSProyecdodegardo/Archivos-proyecto-de-grado repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Placa1 design in my own project?

The repository has no license, so all rights stay with LEOSProyecdodegardo. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Placa1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in Archivos-proyecto-de-grado

Similar boards