HardLabs

Eightpots

little-scale·eightpots

Eightpots PCB layout, top view — open source NXP board by little-scale

About the Eightpots PCB

Eightpots is an open source NXP PCB design by little-scale, published on GitHub. It is a 2-layer board measuring 143.5 × 45.7 mm, with 19 components from 4 distinct parts.

Its main chip is the Teensy-LC, from the NXP family. By type, the board carries 10 capacitors and 1 IC.

From the project

Minimal Controller with Eight Pots made with a Teensy LC

Contains Arduino code, Kicad schematics and PCB, generated Gerber and drill files, position and BOM files, and STL files for the casing.

Main components on the Eightpots

Teensy-LC

Eightpots bill of materials (BOM)

19 components, 4 distinct parts.

QtyPartRefs
1
Teensy-LC
U3
8
POT
RV1, RV2, RV5, RV6, RV9, RV10, RV13, RV14
1
C_Polarized
C1
9
C
C2, C5, C6, C9, C10, C13, C14, C17 +1

Eightpots design files

The KiCad project lives in the little-scale/eightpots repository on GitHub; these links point at the commit this page was built from.

Eightpots: common questions

What microcontroller does the Eightpots use?

The Eightpots is built around the Teensy-LC, from the NXP family.

How big is the Eightpots PCB?

The Eightpots measures 143.5 × 45.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Eightpots?

19 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the Eightpots design files?

From the little-scale/eightpots repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Eightpots design in my own project?

The repository has no license, so all rights stay with little-scale. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Eightpots without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug NXP firmware against it before you order a PCB.

Similar boards