HardLabs

Domoticata wall terminal

LoZioo·Domoticata·hardware/schematics/wall_terminal/wall_terminal.kicad_pcb

Domoticata wall terminal PCB layout, top view — open source AVR/Arduino board by LoZioo

About the Domoticata wall terminal PCB

Domoticata wall terminal is an open source AVR/Arduino PCB design by LoZioo, published on GitHub under the MIT license. It is a 2-layer board measuring 35.6 × 39.4 mm, with 21 components from 10 distinct parts.

Its main chip is the ATtiny13A-P, from the AVR/Arduino family. Other key parts include the MAX487E. By type, the board carries 13 resistors, 4 connectors, 2 ICs and 2 capacitors.

From the project

Custom domotic home system.

Main components on the Domoticata wall terminal

MAX487EATtiny13A-P

Domoticata wall terminal bill of materials (BOM)

21 components, 10 distinct parts.

QtyPartRefs
1
MAX487E
U1
1
ATtiny13A-P
U2
1
Reset
J1
1
Conn_02x12_Odd_Even
J2
2
6P6C
J3, J4
1
10uF
C1
1
100nF
C2
11
R
R1, R2, R3, R4, R5, R6, R7, R8 +3
1
1k
R12
1
120
R13

Domoticata wall terminal design files

The KiCad project lives in the LoZioo/Domoticata repository on GitHub; these links point at the commit this page was built from.

Domoticata wall terminal: common questions

What microcontroller does the Domoticata wall terminal use?

The Domoticata wall terminal is built around the ATtiny13A-P, from the AVR/Arduino family.

How big is the Domoticata wall terminal PCB?

The Domoticata wall terminal measures 35.6 × 39.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Domoticata wall terminal?

21 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Domoticata wall terminal design files?

From the LoZioo/Domoticata repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Domoticata wall terminal design in my own project?

Yes, under the terms of its MIT license, which LoZioo chose for the repository.

Can I test firmware for the Domoticata wall terminal without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Domoticata

Similar boards