Ex4

lutetjeff·ece395·exercises/ex4/ex4.kicad_pcb

Ex4 PCB layout, top view — open source STM32 board by lutetjeff

About the Ex4 PCB

Ex4 is an open source STM32 PCB design by lutetjeff, published on GitHub. It is a 2-layer board measuring 27.9 × 40.6 mm, with 24 components from 18 distinct parts.

Its main chip is the STM32F042F6PX, from the STM32 family. Other key parts include the TLV76733DRVX. By type, the board carries 6 capacitors, 5 resistors, 4 connectors, 3 diodes, 2 ICs and 2 jumpers.

From the project

Repository for UIUC ECE395 project known as RHipoff. A mixture of the Rhythm Horizon and RE:Flex Dance platforms built from the ground up. Current configuration is for four load cells only, but firmware supports up to 16 different panels with four load cells each.

Main components on the Ex4

Ex4 bill of materials (BOM)

24 components, 18 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F042F6PX
STM32L031K6Tx
U1
1
TLV76733DRVX
TLV76733QWDRBxQ1
U2
1
USB_C_Receptacle_USB2.0
J1
1
Programming
J2
1
I2C1
J3
1
GPIO
J4
1
USER_LED_1_EN
JP1
1
USER_LED_2_EN
JP2
1
RST
SW1
1
BOOT
SW2
3
BAT54S
LED
D1, D2, D3
1
1uF
C1
1
2.2U
2.2uF
C2
3
100N
100nF
C3, C4, C5
1
220N
100nF
C6
2
C110776
10k
R1, R2
1
1k
R3
2
2.2
1k
R4, R5

Ex4 design files

The KiCad project lives in the lutetjeff/ece395 repository on GitHub; these links point at the commit this page was built from.

Ex4: common questions

What microcontroller does the Ex4 use?

The Ex4 is built around the STM32F042F6PX, from the STM32 family.

How big is the Ex4 PCB?

The Ex4 measures 27.9 × 40.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ex4?

24 components, from 18 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Ex4 design files?

From the lutetjeff/ece395 repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Ex4 design in my own project?

The repository has no license, so all rights stay with lutetjeff. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Ex4 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in ece395

Similar boards