2FALCD

melair·ktane·PCB/Others/2FALCD/2FALCD.kicad_pcb

2FALCD PCB layout, top view — open source STM32 board by melair

About the 2FALCD PCB

2FALCD is an open source STM32 PCB design by melair, published on GitHub. It is a 2-layer board measuring 65 × 20 mm, with 12 components from 11 distinct parts.

Its main chip is the STM32H562VGT6, from the STM32 family. By type, the board carries 6 connectors, 2 capacitors, 1 IC, 1 switch and 1 resistor.

From the project

Keep Talking and Nobody Explodes - Physical Edition

This is version two of my Keep Talking and Nobody Explodes physical bomb, you may refer to the version-one branch if you wish to see the first version progress.

Main components on the 2FALCD

2FALCD bill of materials (BOM)

12 components, 11 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32H562VGT6
HT16C21A-28
U1
1
2223-UJ20-C-H-G-SMT-1A-P16
VCC
J2
1
STOCK/HEADER
/INT
J3
1
S9171
SDA
J4
1
S9171
SCL
J5
1
S9171
VLCD
J6
1
2223-MSD-11-A
GND
J7
1
~
DS1
1
CKN12220-1
Interact
SW1
2
0.1μF
C1, C2
1
10k
R1

2FALCD design files

The KiCad project lives in the melair/ktane repository on GitHub; these links point at the commit this page was built from.

2FALCD: common questions

What microcontroller does the 2FALCD use?

The 2FALCD is built around the STM32H562VGT6, from the STM32 family.

How big is the 2FALCD PCB?

The 2FALCD measures 65 × 20 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the 2FALCD?

12 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the 2FALCD design files?

From the melair/ktane repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the 2FALCD design in my own project?

The repository has no license, so all rights stay with melair. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the 2FALCD without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in ktane

Similar boards