Roomlight hw

MG-5·roomlight_hw

Roomlight hw PCB layout, top view — open source STM32 board by MG-5

About the Roomlight hw PCB

Roomlight hw is an open source STM32 PCB design by MG-5, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 47.4 × 41.4 mm, with 68 components from 31 distinct parts.

Its main chip is the STM32F103CBTx, from the STM32 family. Other key parts include the INA180A, ESP-07, MIC4690 and MIC5060. By type, the board carries 28 capacitors, 15 resistors, 7 ICs, 6 connectors, 5 diodes and 3 transistors.

From the project

PCB with STM and ESP8266 to controll addressable LEDs

Main components on the Roomlight hw

Roomlight hw bill of materials (BOM)

68 components, 31 distinct parts.

QtyPartRefs
1
INA180A
U1
1
STM32F103CBTx
U2
1
ESP-07
U3
1
MIC4690
U4
3
MIC5060
U5, U6, U7
3
IRF8734
Q1, Q2, Q3
1
ABM3B-16MHz
Y1
1
24V_Conn
J1
1
LOADs
J2
1
UART2
J3
1
DATAs
J4
1
Touch_SW
J5
1
SWD
J6
1
Fuse
F1
1
B260A
D1
1
LED_RED
D2
1
LED_GREEN1
D3
1
LED_GREEN2
D4
1
LED_GREEN3
D5
1
Ferrite_Bead_Small
FB1
Show 11 more
QtyPartRefs
1
68u
L1
15
100n
C1, C2, C3, C4, C7, C9, C10, C11 +7
2
15p
C5, C6
8
10u
C8, C12, C16, C20, C21, C24, C26, C28
1
15u
C13
1
10n
C18
1
220u
C19
9
R
R1, R6, R7, R10, R11, R12, R13, R14 +1
1
R_Shunt
R2
4
10k
R3, R4, R5, R8
1
1k
R9

Roomlight hw design files

The KiCad project lives in the MG-5/roomlight_hw repository on GitHub; these links point at the commit this page was built from.

Roomlight hw: common questions

What microcontroller does the Roomlight hw use?

The Roomlight hw is built around the STM32F103CBTx, from the STM32 family.

How big is the Roomlight hw PCB?

The Roomlight hw measures 47.4 × 41.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Roomlight hw?

68 components, from 31 distinct parts. The full bill of materials is listed on this page.

Where can I download the Roomlight hw design files?

From the MG-5/roomlight_hw repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Roomlight hw design in my own project?

Yes, under the terms of its GPL-3.0 license, which MG-5 chose for the repository.

Can I test firmware for the Roomlight hw without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards