HardLabs

Kicad Eclub session

MrigeeshAshwin·Kicad_Eclub_session

Kicad Eclub session PCB layout, top view — open source AVR/Arduino board by MrigeeshAshwin

About the Kicad Eclub session PCB

Kicad Eclub session is an open source AVR/Arduino PCB design by MrigeeshAshwin, published on GitHub. It is a 2-layer board measuring 82 × 50 mm, with 14 components from 7 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. Other key parts include the MAX30102 and SSD1306. By type, the board carries 4 resistors, 3 switches, 3 capacitors, 2 ICs, 1 module and 1 diode.

From the project

Before going into Kicad PCB design editor make sure you have done your board setup. Navigate it through file->Board_Setup

Main components on the Kicad Eclub session

MAX30102SSD1306Arduino_Nano_v3.x

Kicad Eclub session bill of materials (BOM)

14 components, 7 distinct parts.

QtyPartRefs
1
MAX30102
U1
1
SSD1306
U2
1
Arduino_Nano_v3.x
A1
3
SW_Push
SW1, SW2, SW3
1
LED
D1
3
100n
C1, C2, C3
4
1K
R1, R2, R3, R4

Kicad Eclub session design files

The KiCad project lives in the MrigeeshAshwin/Kicad_Eclub_session repository on GitHub; these links point at the commit this page was built from.

Kicad Eclub session: common questions

What microcontroller does the Kicad Eclub session use?

The Kicad Eclub session is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the Kicad Eclub session PCB?

The Kicad Eclub session measures 82 × 50 mm, has 2 copper layers and is 1.600198 mm thick.

How many components are on the Kicad Eclub session?

14 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Kicad Eclub session design files?

From the MrigeeshAshwin/Kicad_Eclub_session repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Kicad Eclub session design in my own project?

The repository has no license, so all rights stay with MrigeeshAshwin. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Kicad Eclub session without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards