HardLabs

ATtinyBoard

nick1076·Learning-Module-Boards·Modules/Module 2/ATtinyBoard/ATtinyBoard.kicad_pcb

ATtinyBoard PCB layout, top view — open source AVR/Arduino board by nick1076

About the ATtinyBoard PCB

ATtinyBoard is an open source AVR/Arduino PCB design by nick1076, published on GitHub. It is a 2-layer board measuring 29.8 × 18.8 mm, with 6 components from 6 distinct parts.

Its main chip is the ATtiny412-SS, from the AVR/Arduino family. By type, the board carries 1 IC, 1 connector, 1 switch, 1 diode, 1 capacitor and 1 resistor.

Main components on the ATtinyBoard

ATtiny412-SS

ATtinyBoard bill of materials (BOM)

6 components, 6 distinct parts.

QtyPartRefs
1
ATtiny412-SS
U1
1
Conn_01x03
J1
1
SW_Push
SW1
1
LED
D1
1
1uF
C1
1
1k
R1

ATtinyBoard design files

The KiCad project lives in the nick1076/Learning-Module-Boards repository on GitHub; these links point at the commit this page was built from.

ATtinyBoard: common questions

What microcontroller does the ATtinyBoard use?

The ATtinyBoard is built around the ATtiny412-SS, from the AVR/Arduino family.

How big is the ATtinyBoard PCB?

The ATtinyBoard measures 29.8 × 18.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the ATtinyBoard?

6 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the ATtinyBoard design files?

From the nick1076/Learning-Module-Boards repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the ATtinyBoard design in my own project?

The repository has no license, so all rights stay with nick1076. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the ATtinyBoard without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Learning-Module-Boards

Similar boards