PoucetV3

nicolettijones·PoucetV3·PoucetV3/PoucetV3.kicad_pcb

PoucetV3 PCB layout, top view — open source STM32 board by nicolettijones

About the PoucetV3 PCB

PoucetV3 is an open source STM32 PCB design by nicolettijones, published on GitHub under the MIT license. It is a 2-layer board measuring 128.9 × 83.7 mm, with 138 components from 15 distinct parts.

Its main chip is the STM32G0B1CBTx, from the STM32 family. Other key parts include the SRV05-4 and XC6206P332MR. By type, the board carries 60 diodes, 7 capacitors, 3 ICs, 3 resistors, 2 connectors and 2 switches.

It belongs with the keyboards designs in this gallery.

From the project

Thumb-sized keyboard with thumbstick pointer for handheld devices

The test PCB has been ordered and received, and has been mostly assembled but I need a hot air station to solder the chip, so as of now it has not been tested yet.

PoucetV3, from the project README
From the project README

Main components on the PoucetV3

PoucetV3 bill of materials (BOM)

138 components, 15 distinct parts.

QtyPartRefs
1
STM32G0B1CBTx
U1
1
SRV05-4
U2
1
XC6206P332MR
U3
1
USB_C_Receptacle_USB2.0_16P
J1
1
PSP1000 Joystick
J2
1
1000mA
F1
60
Tact_Switch
KEY1, KEY2, KEY3, KEY4, KEY5, KEY6, KEY7, KEY8 +52
1
SW_Push
SW1
1
SW_SPDT
SW2
60
1N4148W
D1, D2, D3, D4, D5, D6, D7, D8 +52
1
4.7uF
C1
3
0.1uF
C2, C4, C5
3
1uF
C3, C6, C7
1
10k
R1
2
5.1k
R2, R3

PoucetV3 design files

The KiCad project lives in the nicolettijones/PoucetV3 repository on GitHub; these links point at the commit this page was built from.

PoucetV3: common questions

What microcontroller does the PoucetV3 use?

The PoucetV3 is built around the STM32G0B1CBTx, from the STM32 family.

How big is the PoucetV3 PCB?

The PoucetV3 measures 128.9 × 83.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the PoucetV3?

138 components, from 15 distinct parts. The full bill of materials is listed on this page.

Where can I download the PoucetV3 design files?

From the nicolettijones/PoucetV3 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the PoucetV3 design in my own project?

Yes, under the terms of its MIT license, which nicolettijones chose for the repository.

Can I test firmware for the PoucetV3 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards