HardLabs

DC34 Main Badge Fuzzer SAO

NilbinSec·DC34_Main_Badge_Fuzzer_SAO

DC34 Main Badge Fuzzer SAO

About the DC34 Main Badge Fuzzer SAO PCB

DC34 Main Badge Fuzzer SAO is an open source AVR/Arduino PCB design by NilbinSec, published on GitHub. It is a board, with 15 components from 8 distinct parts.

Its main chip is the ATtiny1614-SS, from the AVR/Arduino family. By type, the board carries 4 diodes, 4 resistors, 2 switches, 2 capacitors, 1 IC and 1 crystal.

It belongs with the wearables designs in this gallery.

From the project

NilbinSec SAO for the DC34 Conference Badge that serves as a fuzzing tool for potential badge challenges.

This SAO is designed as a tool for hackers who want a quick way to fuzz specific parts of the DEF CON 34 main conference badge based on the initial information DEF CON released about the badge prior to the conference. This may be insanely useful, or may be completely useless in solving the annual badge challenge. Moreover, Mode 1 may harm your badge depending on how the badge designer has set up the GPIO pins.

Main components on the DC34 Main Badge Fuzzer SAO

ATtiny1614-SS

DC34 Main Badge Fuzzer SAO bill of materials (BOM)

15 components, 8 distinct parts.

QtyPartRefs
1
ATtiny1614-SS
U1
1
Badgelife_sao_connector_v169bis
X1
1
Conn_01x03_Pin
J1
2
SW_Push
SW1, SW2
4
LED
D1, D2, D3, D4
1
C100nF
C1
1
C10uF
C2
4
R470
R1, R2, R3, R4

DC34 Main Badge Fuzzer SAO design files

The KiCad project lives in the NilbinSec/DC34_Main_Badge_Fuzzer_SAO repository on GitHub; these links point at the commit this page was built from.

DC34 Main Badge Fuzzer SAO: common questions

What microcontroller does the DC34 Main Badge Fuzzer SAO use?

The DC34 Main Badge Fuzzer SAO is built around the ATtiny1614-SS, from the AVR/Arduino family.

How many components are on the DC34 Main Badge Fuzzer SAO?

15 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the DC34 Main Badge Fuzzer SAO design files?

From the NilbinSec/DC34_Main_Badge_Fuzzer_SAO repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the DC34 Main Badge Fuzzer SAO design in my own project?

The repository has no license, so all rights stay with NilbinSec. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the DC34 Main Badge Fuzzer SAO without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards