HardLabs

Beatervan

ojthetiny·beatervan

Beatervan PCB layout, top view — open source AVR/Arduino board by ojthetiny

About the Beatervan PCB

Beatervan is an open source AVR/Arduino PCB design by ojthetiny, published on GitHub. It is a 2-layer board measuring 242.9 × 96.8 mm, with 99 components from 8 distinct parts.

Its main chip is the ProMicro, from the AVR/Arduino family. By type, the board carries 52 switches, 46 diodes and 1 IC.

Main components on the Beatervan

ProMicro

Beatervan bill of materials (BOM)

99 components, 8 distinct parts.

QtyPartRefs
1
ProMicro
U1
39
MX_LED
SW1, SW5, SW6, SW7, SW9, SW10, SW11, SW13 +31
4
MX_LED
SW2, SW4, SW12, SW30
3
MX_LED
SW3, SW40, SW46
4
MX_LED
SW8, SW31, SW35, SW47
1
MX_LED
SW19
1
MX_LED
SW26
46
1N4148
D1, D2, D3, D4, D5, D6, D7, D8 +38

Beatervan design files

The KiCad project lives in the ojthetiny/beatervan repository on GitHub; these links point at the commit this page was built from.

Beatervan: common questions

What microcontroller does the Beatervan use?

The Beatervan is built around the ProMicro, from the AVR/Arduino family.

How big is the Beatervan PCB?

The Beatervan measures 242.9 × 96.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Beatervan?

99 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Beatervan design files?

From the ojthetiny/beatervan repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Beatervan design in my own project?

The repository has no license, so all rights stay with ojthetiny. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Beatervan without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards