HardLabs

Patch shield analog

OpenElectronicsLab·OpenHardwareExG·kicad-files/rev1/patch-shield-analog.kicad_pcb

Patch shield analog layout, top view — open source AVR/Arduino board by OpenElectronicsLab
Simulate this board

About the Patch shield analog

Patch shield analog is an open source AVR/Arduino PCB design by OpenElectronicsLab, published on GitHub under the GPL-3.0 license. It is a board measuring 197 × 71 mm, with 39 components from 7 distinct parts.

Its main chip is the ARDUINO_SHIELD, from the AVR/Arduino family. By type, the board carries 36 connectors, 1 diode and 1 resistor.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

The OpenHardwareExG is a platform for ECG, EEG, EMG, ENG, EOG, and evoked potential applications. http://openelectronicslab.github.io/OpenHardwareExG/

The OpenHardwareExG is a platform for ECG, EEG, EMG, ENG, EOG, and evoked potential applications.

The schematic can be found at: arduino-ads129x-schematic.pdf

History ------- The OpenHardwareExG platform was originally developed as part of the eeg-mouse project.

Licences -------- Hardware and Hardware Documentation License

This applies to the kicad-files and scad-files directories.

Patch shield analog bill of materials (BOM)

39 components, 7 distinct parts.

QtyPartRefs
33
CONN_1
P1, P2, P3, P4, P5, P6, P7, P8 +25
1
CONN_20X2
P18
1
CONN_5X2
P35
1
ARDUINO_SHIELD
P36
1
VAL**
Hole_M3
1
LED
D1
1
1k
R1

Patch shield analog design files

The KiCad project lives in the OpenElectronicsLab/OpenHardwareExG repository on GitHub; these links point at the commit this page was built from.

Patch shield analog: common questions

What microcontroller does the Patch shield analog use?

The Patch shield analog is built around the ARDUINO_SHIELD, from the AVR/Arduino family.

How big is the Patch shield analog?

The Patch shield analog measures 197 × 71 mm and is 1.6002 mm thick.

How many components are on the Patch shield analog?

39 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Patch shield analog design files?

From the OpenElectronicsLab/OpenHardwareExG repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Patch shield analog design in my own project?

Yes, under the terms of its GPL-3.0 license, which OpenElectronicsLab chose for the repository.

Can I test firmware for the Patch shield analog without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in OpenHardwareExG

Similar boards