HardLabs

PS2PSP

orangeglo·PS2PSP·hardware/PSP_Consolizer/consolizer.kicad_pcb

PS2PSP PCB layout, top view — open source AVR/Arduino board by orangeglo

About the PS2PSP PCB

PS2PSP is an open source AVR/Arduino PCB design by orangeglo, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 52.1 × 37.4 mm, with 20 components from 17 distinct parts.

Its main chip is the ATmega328PB-AU, from the AVR/Arduino family. Other key parts include the MIC5504-3.3YM5 and MCP4651-103E_ST. By type, the board carries 9 connectors, 5 capacitors, 3 ICs, 1 switch, 1 diode and 1 resistor.

From the project

Board to connect a PS2 controller to a PSP 2000 (PSP Consolizer)

These are PCB design and arduino software files for a circuit board that converts a PS2 controller into signals a PSP2000 motherboard can understand. The circuit board is designed to have the PSP power cable routed through it, so you can boot up the PSP and the adapter with a basic toggle switch.

Main components on the PS2PSP

MIC5504-3.3YM5ATmega328PB-AUMCP4651-103E_ST

PS2PSP bill of materials (BOM)

20 components, 17 distinct parts.

QtyPartRefs
1
MIC5504-3.3YM5
U1
1
ATmega328PB-AU
U2
1
MCP4651-103E_ST
U3
1
right ribbon
J1
1
Power IN
J2
1
left ribbon
J3
1
AVR-ISP-6
J4
1
Conn_01x06
J5
1
PS2 Controller
J6
1
center ribbon
J7
1
Analog
J8
1
Power OUT (to PSP)
J9
1
L102021ML04Q
S1
1
LED
D1
2
1 uF
C1, C2
3
0.1 uF
C3, C4, C5
1
68
R1

PS2PSP design files

The KiCad project lives in the orangeglo/PS2PSP repository on GitHub; these links point at the commit this page was built from.

PS2PSP: common questions

What microcontroller does the PS2PSP use?

The PS2PSP is built around the ATmega328PB-AU, from the AVR/Arduino family.

How big is the PS2PSP PCB?

The PS2PSP measures 52.1 × 37.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the PS2PSP?

20 components, from 17 distinct parts. The full bill of materials is listed on this page.

Where can I download the PS2PSP design files?

From the orangeglo/PS2PSP repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the PS2PSP design in my own project?

Yes, under the terms of its GPL-3.0 license, which orangeglo chose for the repository.

Can I test firmware for the PS2PSP without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards